Posts
160
Joined
12/27/2013
Location
AU
benno387
7/25/2017 5:22am
7/25/2017 5:22am
Hey guys
I have a set of pro circuit triple clamps for my 2007 Cr 250
So obviously they are for the 47 mm forks
I have a set of 48 mm forks I want to use on the bike
Has anyone machined the bores to fit the bigger forks
Any problems anyone knows of before I go ahead and do it
Cheers
I have a set of pro circuit triple clamps for my 2007 Cr 250
So obviously they are for the 47 mm forks
I have a set of 48 mm forks I want to use on the bike
Has anyone machined the bores to fit the bigger forks
Any problems anyone knows of before I go ahead and do it
Cheers
I have not yet measured them as my verniers are in my work but I will in the next couple of days
The Shop
Measured up the thickness on the clamps and measured up both sets of forks
Any opinions ?
Clamp thickness outside
top 4.6mm
Bottom 5.6
Showa 47
Top 53.2
Bottom 58.5
Showa 48
Top 54
Bottom 59.1
Post a reply to: Pro circuit clamps machining