Kx125 2002 carb rebuild

Craigyw1984
Edited Date/Time 8/19/2020 3:40pm
Rebuilding my 02 Mikuni carb and the new kit has this o-ring supplied. Any ideas where it goes as I never took one out my old setup. Any help much appreciated guys.

|
kb228
Profile picture for user kb228
Posts
6161
Joined
1/31/2018
Location
Mansfield, OH US
kb228 8/14/2020 3:03pm
8/14/2020 3:03pm


Float valve
Craigyw1984 8/15/2020 12:54am
8/15/2020 12:54am
I never removed this small o-ring. The float valve needle is a tapered rubber, can't see where the oring would go?
Factor E
Profile picture for user Factor E
Posts
734
Joined
9/22/2011
Location
So Cal, CA US
Factor E 8/15/2020 8:24am
8/15/2020 8:24am
maybe miss package
call the company

The Shop

See All »
kb228
Profile picture for user kb228
Posts
6161
Joined
1/31/2018
Location
Mansfield, OH US
kb228 8/15/2020 3:26pm
8/15/2020 3:26pm
I think it goes under the float valve seat.
Craigyw1984 8/17/2020 7:42am
8/17/2020 7:42am
Well got to the bottom of the oring. Also found my powervalve linkage had come loose and was the reason for the crappy running of bike. Adjusted the idle and air screw now although still smokes. Throttle is crisp though, should this clear. Running synthetic 40.1
40acres
Profile picture for user 40acres
Posts
619
Joined
7/23/2017
Location
Houston, TX US
40acres 8/19/2020 3:40pm
8/19/2020 3:40pm
Craigyw1984 wrote:
Well got to the bottom of the oring. Also found my powervalve linkage had come loose and was the reason for the crappy running of bike...
Well got to the bottom of the oring. Also found my powervalve linkage had come loose and was the reason for the crappy running of bike. Adjusted the idle and air screw now although still smokes. Throttle is crisp though, should this clear. Running synthetic 40.1
You could have a leaky crank seal.

Post a reply to: Kx125 2002 carb rebuild