6/8/2020 1:41pm
Awaiting my rebuilt kx125 bored out to 56mm. Any tips on jetting this from the start. Do I jet it as if it were standard and run rich? Had a quick look tonight and pilot is a 633 s-4, needle I believe is stock, 3rd clip. I'm yet to check the main size
|
RyanLester761
Posts
1133
Joined
2/7/2007
Location
El Dorado Hills, CA US
6/10/2020 3:22pm
I would personally leave it, run it and adjust from there. I understand a bigger bore draws more fuel, so I don't think you'll go lean. But, don't quote me on that. Maybe someone else can chime in.
2
jaguar57
Posts
110
Joined
5/14/2017
Location
Miami, FL US
6/10/2020 4:53pm
I doubt it will need any changes if it was jetted correct before
1

Post a reply to: Kx 125

The Latest