Intermittent starting/Delayed Kill switch.

Holeshot922
Posts
116
Joined
11/11/2018
Location
Joshua, TX US
6/19/2020 4:24pm Edited Date/Time 6/23/2020 7:10pm
Hello all, I have a 2017 KX250F PC built bike, has full motor build and GET electronics ignition/mapping. The issue I am having is the bikes kill switch has about a 4-5sec delay before the bike dies. I replaced with a brand new oem kill switch and still same problem.... Also, bike will start perfect hot or cold no change and then out of no where it won't even try to start... wiggle wires, push kill switch button, ect... and then bike will start perfect. Not sure what is going on here, new to the FI system and there components. Any feedback is appreciated.
|
Factor E
Posts
727
Joined
9/22/2011
Location
So Cal, CA US
6/19/2020 9:07pm Edited Date/Time 6/19/2020 9:09pm
check and clean all connections an ground wires
possible moisture in buttons use wd40 and air to blow out
Holeshot922
Posts
116
Joined
11/11/2018
Location
Joshua, TX US
6/23/2020 5:14pm
I have checked/cleaned.... nothing jumped out at me. Bike only has 15hrs on it also.
DynoDan22
Posts
773
Joined
9/7/2011
Location
Victorville, CA US
6/23/2020 7:10pm
Try going back to the stock ECU if you have it. I've heard of some weird issues with the GET ECU's
1
Holeshot922
Posts
116
Joined
11/11/2018
Location
Joshua, TX US
6/24/2020 6:15am
DynoDan22 wrote:
Try going back to the stock ECU if you have it. I've heard of some weird issues with the GET ECU's
Thanks DynoDan22, I have the stock ecu, I could try that, I just didn't know if it would be safe for the "mod" motor. Also, motor/ecu/FI sys is tuned for MR Pro 6 fuel.

Post a reply to: Intermittent starting/Delayed Kill switch.

The Latest