Husky TX300 Clutch not engaging all the way

11/14/2018 7:17pm
Maybe this is normal, not sure. When the bike is off and in gear, even with the clutch pulled, it won't roll. If the bike is running the clutch engages enough to keep it from stalling. Is it possible to adjust the engagement? My previous bike had a rekluse so i didn't notice if it did a similar thing
|
DTR830
Posts
964
Joined
8/14/2017
Location
Mountain Top, PA US
Fantasy
1131st
11/14/2018 7:51pm
oem levers or arc?
11/14/2018 9:11pm
DTR830 wrote:
oem levers or arc?
OEM Levers. I have the twist knob all the way out already
Paw Paw 271
Posts
3640
Joined
4/3/2013
Location
Benton, LA US
11/15/2018 9:16am
Bikes don't roll easy with the clutch pulled in and in gear. It is the nature of the gear reduction system in the trans. Remember that you have a very low overall gearing due to the engines high rpm limits and the speeds derived from said gearing. It is a big mechanical advantage and thus it will not roll easy that way. That is normal.

Paw Paw
1
11/15/2018 9:17am
Bikes don't roll easy with the clutch pulled in and in gear. It is the nature of the gear reduction system in the trans. Remember that...
Bikes don't roll easy with the clutch pulled in and in gear. It is the nature of the gear reduction system in the trans. Remember that you have a very low overall gearing due to the engines high rpm limits and the speeds derived from said gearing. It is a big mechanical advantage and thus it will not roll easy that way. That is normal.

Paw Paw
Good to know. Thanks

The Shop

sandman768
Posts
5958
Joined
3/21/2014
Location
Saratoga Springs, NY US
11/16/2018 6:10pm
Could have air in system, if it creeps when you put it in gear, with clutch pulled in...may need to bleed line...

Post a reply to: Husky TX300 Clutch not engaging all the way

The Latest