Posts
540
Joined
1/29/2018
Location
Bethania, NC
US
How would i go about setting it with the “eyeball” method? How much of an angle do you use? Any tips?
I had the floats set perfectly but while working on my carb this past week the pin fell out and the floats hit the table bending the tab out of whack....
Carb is a PWK38S (yz250)
Thx guys
I had the floats set perfectly but while working on my carb this past week the pin fell out and the floats hit the table bending the tab out of whack....
Carb is a PWK38S (yz250)
Thx guys
Here's a video on it
https://youtu.be/At6vZv6WT9c
Post a reply to: Float Level Help?