Posts: 314
Joined: 5/21/2017
Location: Shelby, NC USA
So I’m installing a crank on a crf 250 and I put the cases back together but I can pull on the stator side of the crank and the whole thing shift from side to side a little. What is causing this? When I put the stator on and clutch basket will it stop? Or is it supposed to do this? I’m like 99% sure it’s not supposed to do this haha
Posts: 3388
Joined: 4/3/2013
Location: Benton, LA USA
Posts: 5504
Joined: 1/31/2018
Location: Mansfield, OH USA
It should stop once the flywheel and all that are on. Just center the crank and you should be good. Im assuming all of the bearings and crank is new tho.
Posts: 314
Joined: 5/21/2017
Location: Shelby, NC USA
Posts: 530
Joined: 4/1/2008
Location: PA, USA
