Cr500 mystery engraving

dougy6790
Edited Date/Time 4/9/2019 4:48pm

Has anyone ever seen this engraving on a cylinder? MP? its on a 95 Cr500 motor I imported from the States. Its had a awesome porting job done. Cheers for any Info.
|
jonboy688
Profile picture for user jonboy688
Posts
438
Joined
9/3/2015
Location
China Grove, NC US
jonboy688 4/9/2019 5:51am
4/9/2019 5:51am
no help with who it is but i had a cr125 not long ago with the same engraving on the cylinder and was the best running 125 i have ever rode
1
RONJ OSE
Profile picture for user RONJ OSE
Posts
352
Joined
3/15/2019
Location
US
RONJ OSE 4/9/2019 6:01am
4/9/2019 6:01am
Mitch payton??? maybe he did some special port work some guy??
Bearuno
Profile picture for user Bearuno
Posts
4146
Joined
6/28/2014
Location
AU
Bearuno 4/9/2019 11:31am
4/9/2019 11:31am
Just be thankful that it doesn't have an S after the MP........

That butchers efforts with conversions are frightening enough, without him getting into porting Whistling
1

The Shop

See All »
project racer 4/9/2019 2:26pm
4/9/2019 2:26pm
Bearuno wrote:
Just be thankful that it doesn't have an S after the MP........

That butchers efforts with conversions are frightening enough, without him getting into porting Whistling
Where has Scooter5002 been ? His thread was gold on that one.
dougy6790 4/9/2019 4:48pm
4/9/2019 4:48pm
jonboy688 wrote:
no help with who it is but i had a cr125 not long ago with the same engraving on the cylinder and was the best running...
no help with who it is but i had a cr125 not long ago with the same engraving on the cylinder and was the best running 125 i have ever rode
I definitely agree mate whoever it is can really work a cylinder good to know it wasn't a one off.
dougy6790 4/9/2019 4:56pm
4/9/2019 4:56pm
RONJ OSE wrote:
Mitch payton??? maybe he did some special port work some guy??
That was definitely a thought between a few of my mates. Be good to turn up more info on it.
dougy6790 4/9/2019 5:19pm
4/9/2019 5:19pm
Bearuno wrote:
Just be thankful that it doesn't have an S after the MP........

That butchers efforts with conversions are frightening enough, without him getting into porting Whistling
Haha yeah mate definitely I read a thread a while back that's some scary stuff but without the DIY superstars what would give the rest of us a giggle.....Grinning
Well the motor was parted out of a very well setup (but decaying) Cr500 that had been sitting quiet a while with very brittle seals which is reassuring it hadn't been touched in a long time....

Post a reply to: Cr500 mystery engraving