Carburetor leaking

Related:
Create New Tag

2/20/2019 2:11 PM

I just adjusted the height on the needle. Is this causing it to pour gas?

|

2/20/2019 3:03 PM

Yep. Make sure the seam on your floats are parallel with your gasket surface of the bowl. Sounds like you got your tang wrong.

|

3/12/2019 1:30 PM

2_smokers_matter2197 wrote:

I just adjusted the height on the needle. Is this causing it to pour gas?

Make sure your gaskets are good on the carb. I had a torn bowl gasket on my cr125 and it poured gas. Also make sure the float isn't stuck. If you haven't solved the issue already.

|

3/12/2019 2:35 PM

Where is the gas coming from?

If it's coming from the tube on the bottom of the float bowl you either A) Have the float adjusted wrong and have to much fuel in the float bowl, or cool Your float needle is sticking.

|

2017 RMZ450
2005 YZ250-sold :,(
1998 YZ250
2005 KX250F

80% of the time it works every time
IG @hammerfamily_4 & @2HRacing
Thanks to : Factory Effex, N2Dirt, Acerbis, DT1, Fasthouse, Matix, FMF, ASV, 100% & Mika Metals

3/12/2019 4:19 PM

Which needle did you adjust? The needle on the slide or the needle seat valve in the bowl?

|