Posts
116
Joined
11/11/2018
Location
Joshua, TX
US
Edited Date/Time
11/23/2020 10:04am
Hello, I have 2016 pro circuit built kx250f. I am having what I suspect to be an electrical issue. Bike will be hesitant to start at times and every time you go to shut off the bike there is a 3-5 sec delay at the kill switch before bike will actually die. Couple things I noticed, the GET map selector switch was never hooked up ( still in the box). Also the factory electronic holeshot device is not hooked up. Wondering if any of these may be causing my issues. I also replaced kill switch with new oem thinking it was failing but still same issue.
Can find any real clear instructions on how the GET data setup is supposed to be installed. Any help would be appreciated. Bike runs perfect when it will start and valves are in spec. Attached pic of my bike.
Can find any real clear instructions on how the GET data setup is supposed to be installed. Any help would be appreciated. Bike runs perfect when it will start and valves are in spec. Attached pic of my bike.
https://youtu.be/F36DWnUW9LQ
I will shoot them an email and go from there.
Thank you.
Post a reply to: Anyone familiar with the GET data setups???