How do you do it? Looking to get the fork lowers anodized while they are apart for a rebuild. I don't see a set screw, etc.
Thanks
How do you do it? Looking to get the fork lowers anodized while they are apart for a rebuild. I don't see a set screw, etc.
Thanks
I use a seal driver and an old tube, rap the tube around the fork put the seal driver on rubber and place Fork leg in a vice, take a rubber mallet after Heating the lower Fork up just start tapin it until it comes loose.
They are held on by a shit ton of red loctite and threaded onto the bottom
If you're not mixing gas, you're not haulin ass.
Thanks for the replies
Does anybody have the manual for a ‘98 rm 125 or 250? Looking for the fork disassembly procedure ,