1995 CR250 help needed to remove linkage bearing

2/2/2020 8:22pm
One hole in the linkage has two bearings. Can they be pushed out or do you have to pull them?
|
mxrose3
Posts
2170
Joined
8/17/2006
Location
Delmar, DE US
Fantasy
853rd
2/4/2020 11:52am
I've pushed them both out with a press before without much issue. Hit them with some PB blaster ahead of time.
RyanLester761
Posts
1133
Joined
2/7/2007
Location
El Dorado Hills, CA US
2/5/2020 10:56am
It finally came out.
Good job. Heat always helps on stuff like that too. Heat the aluminum to swell the opening. Often times, the bearing will just about fall out on its own.

Post a reply to: 1995 CR250 help needed to remove linkage bearing

The Latest