Posts
19
Joined
3/29/2017
Location
Brisbane
AU
Hi guys,
I'm after some help on this one, I recently purchased a 2nd hand pro circuit link arm for my Yz250f. Whilst cleaning it up I noticed the bearings were knackered. I was wondering if anyone on here has replaced them before? It appears there is a machined step located on the inside of the link which locates the bearing and prevents me from pressing the bearing out from one side and coming out the other.
Is there a special tool or technique required to remove the bearings?
I'm seeking some advice as I don't want to damage the link.
Cheers Aaron
I'm after some help on this one, I recently purchased a 2nd hand pro circuit link arm for my Yz250f. Whilst cleaning it up I noticed the bearings were knackered. I was wondering if anyone on here has replaced them before? It appears there is a machined step located on the inside of the link which locates the bearing and prevents me from pressing the bearing out from one side and coming out the other.
Is there a special tool or technique required to remove the bearings?
I'm seeking some advice as I don't want to damage the link.
Cheers Aaron
Post a reply to: 14' Yz250f pro circuit link arm bearing replacement