preferred bar bend?

alexmorris319
Profile picture for user alexmorris319
Posts
54
Joined
11/24/2010
Location
Saint Charles, MO US
alexmorris319
Edited Date/Time 1/5/2014 10:35am
What's everyone's favorite? I ride an rmz450 and the stock fatbars are good but it seems like I see most people running twinwall renthals...
|
moto314
Profile picture for user moto314
Posts
892
Joined
10/20/2009
Location
Mooresville, NC US
moto314 12/31/2013 8:05am
12/31/2013 8:05am
You asking about bend or type of bar? I use the Henry/ Reed bend.
slipdog
Profile picture for user slipdog
Posts
10044
Joined
7/25/2009
Location
Nor Cal, CA US
slipdog 12/31/2013 8:40am
12/31/2013 8:40am
Pro-Taper RM/Carmichael low
711mx
Profile picture for user 711mx
Posts
40
Joined
12/22/2013
Location
GB
711mx 12/31/2013 9:36am
12/31/2013 9:36am
KTM bend as they don't have much sweep and are medium height

The Shop

See All »
bd
Profile picture for user bd
Posts
5976
Joined
4/6/2007
Location
Las Vegas, NV US
bd 12/31/2013 1:55pm
12/31/2013 1:55pm
Renthal CR/RC/Trey Canard Bend - Twin Wall 997. Fat Bar has almost the same bar (CR bend).

Twin Wall will be more rigid than Fat Bar - some riders like the rigid feel.
lumpy790
Profile picture for user lumpy790
Posts
9284
Joined
9/18/2007
Location
York, SC US
lumpy790 1/2/2014 7:37am
1/2/2014 7:37am
everyones preference is different in what bend they like. I ran Pro Taper CR Low for years but they were discontinued.

I like low and flat and go to the bar manufacturers web site and compare the specs.
slipdog
Profile picture for user slipdog
Posts
10044
Joined
7/25/2009
Location
Nor Cal, CA US
slipdog 1/2/2014 9:13am
1/2/2014 9:13am Edited Date/Time 1/2/2014 9:15am
lumpy790 wrote:
everyones preference is different in what bend they like. I ran Pro Taper CR Low for years but they were discontinued. I like low and flat...
everyones preference is different in what bend they like. I ran Pro Taper CR Low for years but they were discontinued.

I like low and flat and go to the bar manufacturers web site and compare the specs.
RM/Carmichael low is the lowest and flattest bar available you short fuck!

I ran the CR low for years until I looked and found the RM had a little less sweep.
alexmorris319
Profile picture for user alexmorris319
Posts
54
Joined
11/24/2010
Location
Saint Charles, MO US
alexmorris319 1/5/2014 10:35am
1/5/2014 10:35am
I was just wondering which bend people like best, they don't make renthal twinwall bars in the stock Suzuki fatbar bend and I see every Suzuki guy running fatbars and I would like to know what Suzuki guys run but im a taller rider, 6 foot.

Post a reply to: preferred bar bend?