Pulling 2 stroke motor getting hung up.

3rdgearpinned
Profile picture for user 3rdgearpinned
Posts
526
Joined
7/8/2016
Location
In the Mountains, NC US
3rdgearpinned
Hey guys I'm doing a 2000 CR125 build and I've tried to search to no avail. I want to pull the motor so I can acid etch and sand the frame. Well, my question is, does the flywheel have to be pulled to unhook the ignition wires? I can get the wires in the front of the flywheel unhooked but there is a wire running in behind the flywheel.

Thanks in advance.
|
Kx125rider 7/17/2016 5:40pm
7/17/2016 5:40pm
I would guess you have to pull it. I have no experience with the bike so i may be wrong.
colintrax
Profile picture for user colintrax
Posts
4704
Joined
8/25/2015
Location
Taylorsville, GA US
Fantasy
2342nd
colintrax 7/17/2016 5:45pm
7/17/2016 5:45pm
If you want to undo the wiring from the engine, but there should be an electrical connector further up the frame if your goal is to simply pull the engine out.
3rdgearpinned
Profile picture for user 3rdgearpinned
Posts
526
Joined
7/8/2016
Location
In the Mountains, NC US
3rdgearpinned 7/17/2016 5:48pm
7/17/2016 5:48pm
Yea I saw also. Was gonna try it but it runs into another set of wires. May check it out again. Thanks

Post a reply to: Pulling 2 stroke motor getting hung up.