I just bought a yzf 250 2017 and i will show you the basic mods that i did mainly for protection, i think for an amateur level the engine is very good so for now i will leave it stock.
The radiators are from china only for backup situations.
Protaper handlebar ricky carmichael bend.
Ribbed seat cover.
Twin air filter.
Moto master 270mm oversized flame rotor kit.
Subframe plastic guard (from a wrf model).
Pro taper grips.
Motion pro thottle tube.
Ufo plastics except from the front numberplate that is cycra.
Gytr clutch cover.
Gytr skid plate.
New plastics.
I cut in half an old hose that i had and put it with two zip ties for protection.
This is a GYTR skid plate, good quality.
Moto master 270mm flame oversized rotor kit, it has a little bit more power than stock.
The radiators are from china only for backup situations.
Protaper handlebar ricky carmichael bend.
Ribbed seat cover.
Twin air filter.
Moto master 270mm oversized flame rotor kit.
Subframe plastic guard (from a wrf model).
Pro taper grips.
Motion pro thottle tube.
Ufo plastics except from the front numberplate that is cycra.
Gytr clutch cover.
Gytr skid plate.
New plastics.
I cut in half an old hose that i had and put it with two zip ties for protection.
This is a GYTR skid plate, good quality.
Moto master 270mm flame oversized rotor kit, it has a little bit more power than stock.
These are the graphics that i put on. I wanted the end result to be as clean as possible, i don't like to put a lot of colors.
The Shop
https://www.facebook.com/kalia.dxl?fref=ts
Good job man enjoy it.
Post a reply to: 2017 yzf 250 build