Posts: 753
Joined: 6/29/2014
Location: Honolulu, HI USA
Edited Date/Time:
Hey guys I'm gonna take my '79 CR250 out to Pala on saturday for a shakedown ride. Does anyone know the SLR - suspension leverage ratio for these bikes? I need to know to use the charts for recommended pressures in my Fox Airshox
Thanks
and Stevie - if you're reading this - what was the recommended measurement from the top of the triple clamps down to the front axle for 43mm forks?
Thanks
Posts: 10625
Joined: 8/16/2006
Location: Sacramento, CA USA
Posts: 753
Joined: 6/29/2014
Location: Honolulu, HI USA
Posts: 530
Joined: 2/10/2014
Location: GBR
I run them at 914mm John.
Check out our website! www.phildentonengineering.com E-mail if you don't see what you're after!
The finest Titanium, Stainless Steel and Billet alloy components in the world!
Engine building, Race prep, Restoration
https://www.facebook.com/PhilDentonEngineering
Posts: 180
Joined: 7/28/2016
Location: Huntsville, AL USA
Posts: 753
Joined: 6/29/2014
Location: Honolulu, HI USA
well things didnt go as planned. my buddy was gonna prep my bike before i got there - needed a few things done, like a shock guard to protect the airshock from the chain, and a few other minor things. then my buddy hurt his knee at work, and didnt get anything done. i simply didnt have time to work on a bike, so i just grabbed my husky and raced it at Pala. 105 degrees that day!!
so unfortunately the CR ride report will have to wait for my next trip to CA
thanks Stevie!
