Posts
3
Joined
1/13/2018
Location
Apple Valley, CA
US
Edited Date/Time
1/17/2018 12:18pm
Hey everyone I’m new here. I am rebuilding a 1976 Honda cr125m for my wife and I got a cylinder from a 1976 MT125 to replace the old bad barrel. I did this so that it would be easier for her to ride being better on the low end and not so wild in the higher gears. I just have a question as to what the port on the left side of the cylinder (if your on the bike) that it right behind the intake manifold. There is nothing there now but a threaded hole. Can I just cap that or it something more important? Thanks a lot!
Post a reply to: MT125 Cylinder