Posts
31
Joined
9/6/2014
Location
Columbus, OH
US
Restoring an ‘83 CR125. I’ve already split the cases and replaced all of the bearings. Tranny is good and back in, cases re-assembled. As I have only ever restored old XRs, I’m a little in the dark on crank seals. I have them pressed in, backside facing out, but do they sit flush to the outer edge of their seat or are they supposed to be recessed? .
Any guidance from and old 2-smoker would be appreciated.
Any guidance from and old 2-smoker would be appreciated.
Is that right?
Paw Paw
The Shop
Incidentally, I am using the factory repair manual but the photos and step-by-step instructions suck.
I have installed a seal backwards on purpose once, beacuse there was damage on the surface, and it worked. But that was on a 50cc Franco morini..
Paw Paw
Thanks guys.
Post a reply to: Crank Seals ‘83 CR