Posts: 865
Joined: 12/14/2018
Location: ITA
Hello guys,
I'm new to the forum. I just bought a '14 kxf 250, and i received it with the black map installed.
I have the white and green thing to plug in, but my question is, how do i remove the black one and plug the one i want? Is there a tutorial video or something? I don't want to damage the bike.
Thanks,
Matt193
rarararaataatatatata
Posts: 578
Joined: 1/1/2008
Location: MA, USA
Its pretty self explanitory. Take a close look at the bottom part of the coupler. You pinch part of the connector and pull.
There are a lot of similar plugs on modern bikes, cars, power equipment etc. Some of them much more of a pain than this EFI coupler. I always make sure the plug is clean, the terminals have dielectric grease on them, and I apply a thin lube to the mating surfaces so that it’s easy to pull apart the next time.
Posts: 19439
Joined: 6/15/2010
Location: Bowie, MD USA
pCp 252 wrote:
Its pretty self explanitory. Take a close look at the bottom part of the coupler. You pinch part of the connector and pull.
There are a lot of similar plugs on modern bikes, cars, power equipment etc. Some of them much more of a pain than this EFI coupler. I always make sure the plug is clean, the terminals have dielectric grease on them, and I apply a thin lube to the mating surfaces so that it’s easy to pull apart the next time.
X2, and info is in the manual.
Posts: 5506
Joined: 1/31/2018
Location: Mansfield, OH USA
