Posts: 411
Joined: 1/12/2011
Location: Trussville, AL USA
Looking at getting a motovan. The one im interested in has the rings on the side/close to the wall. Looking for a wheel chock that I don’t have to drill in the floor, can use the rings on the walls for the straps. Do you guys know of a product?
Thanks
Posts: 1911
Joined: 6/3/2018
Location: Bennett, CO USA
Just bolt the chock to a piece of plywood or aluminum tread plate, use your rings. The weight will hold the chock(base plate) down.
vomiting equals disqualification.
Posts: 411
Joined: 1/12/2011
Location: Trussville, AL USA
So just roll the bike onto the wheel chock and strappng the bike down by handle bars will keep it in place? Is that correct?
Posts: 1911
Joined: 6/3/2018
Location: Bennett, CO USA
Edited Date/Time:
yz25 wrote:
So just roll the bike onto the wheel chock and strappng the bike down by handle bars will keep it in place? Is that correct?
Yep, just make the base a decent size. Can always use some grip tape too or rubber pad. I have never had a problem with this setup. Especially if the base is set against the seats or similar.
vomiting equals disqualification.
Posts: 9409
Joined: 8/16/2006
Location: CO, USA
yz25 wrote:
Looking at getting a motovan. The one im interested in has the rings on the side/close to the wall. Looking for a wheel chock that I don’t have to drill in the floor, can use the rings on the walls for the straps. Do you guys know of a product?
Thanks
Pingle makes a removable bike chock that I use. The mounts have to be drilled into the floor but the chock comes right off , not sure if that helps you or not. I have used them for years and think there great. 
Ed Johnson
