Posts
3900
Joined
3/5/2007
Location
Adelaide
AU
tobz
4/2/2017 6:35pm
4/2/2017 6:35pm
Edited Date/Time
4/2/2017 6:37pm
After a couple of track days with the new moto 9 Flex, I'm trying to get in behind the mouth piece to clear out mud that's caked into the foam. There's no screws to undo and I've tried separating it forcefully but being careful not to gouge anything out trying to jam something in there to separate it.
I've contacted Bell directly and while a recieved a pretty prompt response, it was basically just confirmation that "yes it does pull out".
Anyone confirm that it just takes a shitload of pressure to pop out? Or is there a nack or where to actually lever it from?
Thanks in advance.
I've contacted Bell directly and while a recieved a pretty prompt response, it was basically just confirmation that "yes it does pull out".
Anyone confirm that it just takes a shitload of pressure to pop out? Or is there a nack or where to actually lever it from?
Thanks in advance.
not sure if the flex is any diff?
Post a reply to: How do you remove Bell Moto 9 mouthpiece?