Posts: 352
Joined: 5/21/2017
Location: Carlsbad, CA USA
Selling an 07 khi kx450 engine ,has tim ferry #15 clutch cover , full ti hardware on entire engine , khi clutch actuator, custom ti valves and porting , cams with adjustable timing gears , custom coated and drilled tappetsfactory khi serial # on case ....no clutch or water pump cover but everything else is there $2500 
Posts: 693
Joined: 11/9/2011
Location: Broomfield, CO USA
Posts: 87
Joined: 1/11/2011
Location: pittsburgh, PA USA
Posts: 352
Joined: 5/21/2017
Location: Carlsbad, CA USA
bj.wrobleski wrote:
Why are there washers a bearing laying in the bottom?
They were at the bottom when i pulled cover off , no clutch with the engine the bearing and washer go on the clutch rod
Posts: 585
Joined: 12/7/2014
Location: PA, USA
bj.wrobleski wrote:
Why are there washers a bearing laying in the bottom?
They go against the pressure plate that the rod pushes on when u pull the clutch lever in.
Those engines were fast stock! I bet that thing rips!
Posts: 1034
Joined: 7/10/2016
Location: CA, USA
