Posts
564
Joined
9/2/2018
Location
FR
Edited Date/Time
9/17/2022 11:15pm
I could have built this bike in thousand ways.
I built lot of motorcycle with these famous engine two shots! call big bore.
But this framethat I chose is the one I like(between 2002 to 2016) when we found the right setting of the suspensions or when we used the good stuff..
I hope this will serve to hobbyists, It was a long job to gather all these stuff so that they work well together.
Enjoy and share.
THX.
I built lot of motorcycle with these famous engine two shots! call big bore.
But this framethat I chose is the one I like(between 2002 to 2016) when we found the right setting of the suspensions or when we used the good stuff..
I hope this will serve to hobbyists, It was a long job to gather all these stuff so that they work well together.
Enjoy and share.
THX.
The Shop
bending and sand
Front brake system
Will anyone find from whitch origin these parts are extracted?
Disregard the numbers behind the decimal point, this is a 3D scan and retro-engineering in order to retrace the axes. this value should -be correct and the logic is rather round.
What do you think?
Pit Row
And for that! Well, I am ... what I am!
and tell you this.
I had to cross the road of many people to realize these fantastic motorcycles, some of these people will recognize in the work done.
I had no sponsors, I had to pay everything. I would not mention brands, you will recognize what you will need.
139mm???
144mm???
This is where the work becomes difficult ...
If it's 139mm ?? we will have to cut into the mass
If it's 144 will also have to be "Billet"
Post a reply to: 500 Two Stroke project. "I hope to end up in 2023"