topcat261076's Forum Activity

Reply to Ktm 450 exc-f 2015 magnets gone in to my clutch side crank shaft hole. 3/27/2018 6:41 PM

Chris topcat261076. Ktm 450 exc-f 2015 2 X (2MM BY 2MM )MAGNETS IN CLUTCH SIDE CRANKSHAFT HOLE. I got them little critters out, I used 160mm long by 1.5 mm thick drill bit and 160mm by 0.5mm drill bit. I prised them out with the 2 long, thin drill bits. ... more »

Reply to Ktm 450 exc-f 2015 magnets gone in to my clutch side crank shaft hole. 3/25/2018 3:25 AM

All I wanted to know was there a access hole behind the crankshaft, so I can push them out, the magnets are not stuck fast they just gone to the back of crankshaft hole 3 - 4" in.

Reply to Ktm 450 exc-f 2015 magnets gone in to my clutch side crank shaft hole. 3/25/2018 3:22 AM

Why split the case when I can see the magnets about 3 1/2 inches down the crank shaft hole. Why not use a air sucker or vacuum with reduction kit and 1-2mm diameter pipe. Topcat261076

Reply to Ktm 450 exc-f 2015 free wheel gear in and out movment 2/25/2018 4:11 PM

The freewheel gear moves in and out about 1-2mm. But it never completely disengages the one way sprag on primary gear and the freewheel always moves up fully into the one way sprag when the primary gear moves. It's a weird set up, same as ktm 450 sfx ... more »