Added reply in a thread Let's see/review those 2019 kx450s 10/30/2020 10:19 AM

I do use a lot of clutch so that would make sense. I’m pulling the screen tonight. Thanks man. Much appreciated.

Added reply in a thread Let's see/review those 2019 kx450s 10/29/2020 8:32 AM

Ok all you bench mechanics! I have a 2019 Kx 450. Just did the top end, everything looked great...except for the intake cam. I use Amsoil, change every 3hrs and use twin air filters with No Toil oil. Bike has 60 hours on it. From what I have been told,

... more »
Added reply in a thread Let's see/review those 2019 kx450s 8/26/2020 1:26 PM

Send me a message. We should link up and ride.

Added reply in a thread Let's see/review those 2019 kx450s 8/26/2020 1:11 PM

I do! Love in the springs tho.

Added reply in a thread Let's see/review those 2019 kx450s 8/26/2020 12:57 PM

I’d say the yosh would be your best bet. I have a pc pipe and it gave it more grunt and more midrange pull. I rode a buddy’s bike with the Yosh system was smooth and pulled a little longer. But did not give you the hit the pc system did. Can’t speak ... more »

Added reply in a thread Let's see/review those 2019 kx450s 8/23/2020 5:01 PM

Just a heads up for all you PC TI header pipe fans. Mine and a Buddys head pipe cracked just below the metal flange that goes into the head. HIs was very obvious from the outside and mine was cracking from the inside. Both bikes had around 60 Hrs on ... more »

Added reply in a thread Tomac and that Kawasaki 8/23/2020 4:50 PM

The bike was running, Clutch went out. Eli is notorious clutch abuser on dry conditions. Wet= BYE BYE.

Added reply in a thread Let's see/review those 2019 kx450s 11/9/2019 7:27 AM

So what is the overall consensus on gearing. I live at 6000 feet so I usually go up a tooth on the rear, but I hear good things on a 14 up front. Just looking for ideas,thanks.

Added reply in a thread Let's see/review those 2019 kx450s 11/9/2019 7:22 AM

I did the same thing.... sucks

Added reply in a thread Let's see/review those 2019 kx450s 10/24/2019 6:48 AM

I have a set of the pros, I’ve tried both offsets. The stock offset I felt no noticeable improvement to the bike besides looking bad ass. The other offset would be great for suppercross but for Mx...it was very twitchy.

Added reply in a thread GET RX1 Pro ECU 2019 Kawasaki Kx450 10/12/2019 3:49 PM

Still available?

Added reply in a thread Let's see/review those 2019 kx450s 9/29/2019 6:43 PM

No, or just unplug all together and take it off.

Added reply in a thread Let's see/review those 2019 kx450s 7/24/2019 10:58 AM

I have on the stainless system, not the Ti.

Added reply in a thread Let's see/review those 2019 kx450s 7/1/2019 7:53 PM

On the stock Ecu?

Added reply in a thread Let's see/review those 2019 kx450s 6/18/2019 4:05 PM

I have them, I tried 21 but was too twitchy at higher speeds for me. and not being able to tighten the stem down as tight (to stiffen up steering) as the found on the stock stuff. I went back to 23 and was much better. I could see the 21 being great ... more »

Added reply in a thread Let's see/review those 2019 kx450s 5/31/2019 11:14 AM

Well I think I’ve dumped enough money into this thing. Can’t wait to get it out.

... more »
Added reply in a thread Let's see/review those 2019 kx450s 5/24/2019 6:11 AM

Just had my stuff done by pc and they are saying 101 for me.

Added reply in a thread Let's see/review those 2019 kx450s 5/22/2019 8:06 PM

I’m in the springs, we should ride!

Added reply in a thread Let's see/review those 2019 kx450s 5/20/2019 10:35 AM

Welds are fine. Get an Ironman sprocket, best in the Business . And a two year warranty.

Added reply in a thread Let's see/review those 2019 kx450s 4/13/2019 7:40 AM

Shifter is bent and it also put a hole in the case just above it. Rear fender broke and handle bar mounts twisted.