Added reply in a thread Crank alignment 2/21/2020 5:05 AM

Thanks guys for all the advice. I’ve emailed Ken and crank works for quotes. I’d like to ship the crank and case half to the same place. Need the drain filled and retapped too.

Started new thread Crank alignment 2/17/2020 8:32 PM

Just how easy is it to knock a crank out of alignment? Tried to knock it out with a rubber hammer before getting a right tool to push it out. Do I need to replace it or have it trued? On another note: bearing came out with the crank on the stator side. ... more »

This forum thread has 7 replies

Started new thread Need a welder 2/10/2020 8:53 PM

Does anyone know someone that could fix this? Previous owners helicoil failed. Thankfully I caught this before it grenaded the motor. I’m in the southeast and the closer the better. I’m at a loss on how to fix it. Exterior of the case is fine though.

... more »

This forum thread has 3 replies

Added reply in a thread Case Splitter and Crank Installer Tools 1/26/2020 11:56 AM

Any chance you still have these?

Started new thread WTB: Case Splitter tool 1/25/2020 2:52 PM

I’m wanting to buy a used case splitter tool to fix the drain collar on my 08 KX250f. If anyone has the flywheel puller and clutch holder tool that would be helpful too. Can PayPal the funds.

This forum thread has 2 replies

Added a comment about feature 12 Days of MXMas: ProTaper 12/6/2019 9:00 PM
pastmyprime214

Go one tooth up right?

0 0 0

This feature has 286 comments.

Added a comment about feature 12 Days of MXMas: SKDA 12/6/2019 8:59 PM
pastmyprime214

Might even buy new plastics for these

0 0 0

This feature has 273 comments.

Added reply in a thread WTB 22mm offset clamps for 08 KX250f 4/3/2019 9:07 PM

I’m not sure that they will.

Added reply in a thread Shift gear 36 XL 4/1/2019 8:01 PM

I’m interested in the yellow set

Started new thread WTB 22mm offset clamps for 08 KX250f 3/31/2019 5:40 PM

Please let me know if you have a used set of triple clamps. Not looking to pay $400 for a new set. Thanks.

This forum thread has 3 replies

Started new thread 08 KX250f seat bracket 3/31/2019 5:37 PM

I went to put the seat back on after putting in the air filter and one of the seat brackets snapped off. It wasn’t at the rivot. It snapped at the bend in the metal. Any ideas where I can find a replacement?

This forum thread has 2 replies

Added reply in a thread Kx250f front brake 1/10/2018 9:38 AM

It’s an 08. Farted around with it today and pushed the pistons in. Fluid went up into the reservoir. Pumped the lever a few times and got some of the pressure back. I’m noticing that the first half of the pull has no pressure and then it grabs. Bad line? ... more »

Added reply in a thread Kx250f front brake 1/10/2018 7:21 AM

The only thing I haven’t tried from that list is new line and banjos.

Started new thread Kx250f front brake 1/9/2018 11:07 PM

I rebuilt the master cylinder after finding a torn seal in it. Tried to bleed, only get pressure on the last half of pull and wheel didn’t spin good at all. Pulled caliper off and wheel spun great. Decided to rebuild caliper. Bleed the system and still ... more »

This forum thread has 6 replies

Added a comment about feature Vital MX 12 Days of MXmas: Day 8 12/14/2017 3:25 PM
pastmyprime214

Fragile...is that French?

0 0 0

This feature has 296 comments.

Added a comment about feature Vital MX 12 Days of MXmas: Day 7 12/14/2017 7:59 AM
pastmyprime214

These can replace my O’Neal’s that are too small

0 0 0

This feature has 266 comments.

Added a comment about feature Vital MX 12 Days of MXmas: Day 6 12/12/2017 6:04 PM
pastmyprime214

Would look good on the 08 build

0 0 0

This feature has 261 comments.

Added a comment about feature Vital MX 12 Days of MXmas: Day 5 12/11/2017 11:15 PM
pastmyprime214

Fingers crossed

0 0 0

This feature has 315 comments.

Added a comment about feature Vital MX 12 Days of MXmas: Day 3 12/11/2017 11:13 PM
pastmyprime214

I like it

0 0 0

This feature has 320 comments.

Added a comment about feature Vital MX 12 Days of MXmas: Day 2 12/11/2017 11:12 PM
pastmyprime214

Stopping power!

0 0 0

This feature has 312 comments.