Added reply in a thread Backyard track builders 6/23/2020 9:55 AM

Here's what I use for work around the house and track work. All 3 machines are 40hp. I bought all of them used but don't mind working on machines so I'd rather save money. I'd be into the same machines new about $130+k whereas I'm in only $30k. I push

... more »
Updated photo album Equipment 6/23/2020 9:28 AM
Equipment
  • Excavator
  • Tractor
  • Dozer

This photo album has no comments yet

Added reply in a thread Hobby Track 9/12/2019 4:21 PM

I walked the field and kinda planned it out in my head and then just dropped the tiller and started. We bought the property a couple years ago and I just finished building our house so this kind of stuff was on the back burner. There was no riding through ... more »

Added reply in a thread Hobby Track 9/12/2019 10:01 AM

I finally got a tiller I had bought all fixed up and operational and starting scratching out a track in one of my fields. Eventually I'll extend the track up into the woods and make some technical trail type sections and use the elevation on my property

... more »
Started new thread YZ 85 jetting help 8/10/2019 11:56 PM

I've been getting a YZ85 fixed up for my son and I've got some jetting questions. When wicking the throttle from 1/4 throttlw or idle it falls on its face and dies. If you roll it on it pulls hard. It idles nice and has decent throttle response, just ... more »

This forum thread has 2 replies

Added reply in a thread Environuts called my private track in. 8/9/2019 10:33 AM

Insane. Environmentalists are unreal. They'll probably point at some ruts and point out the soil erosion and ask what your plan is for mitigating it. This stuff really just irks me. Can't people just let things be?

Added reply in a thread YZ85 running super rich. 7/30/2019 12:59 PM

I did and it was right on the money.

Added reply in a thread YZ85 running super rich. 7/30/2019 8:16 AM

I pulled the clutch side cover off and could see the crank bearing through the seal. New seal has been ordered. I pulled the carb out also and all the parts are where they should be. Thanks for that too. It'll be up and running in no time. Thanks guys. ... more »

Added reply in a thread YZ85 running super rich. 7/29/2019 10:33 PM

Are you talking about part 30 on this diagram? YZ Carb breakdown

Added reply in a thread YZ85 running super rich. 7/29/2019 3:42 PM

Good call. I was going all in on carburetion but that could be it. It would work to drain the transmission fluid and then run it to see if the smoke goes away right? Not going to ride it around, just run it on the stand.

Started new thread YZ85 running super rich. 7/29/2019 1:40 PM

I picked up an '02 YZ85 for my boy and have been fixing it up for him. It's got a new topend, air filter, carb's been gone through. All the jetting is stock and in the video the needle is clipped at the leanest setting. Fuel is premium @ 32:1 synthetic ... more »

This forum thread has 9 replies

Added reply in a thread 5th wheel livin 4/11/2019 12:20 PM

I lived in one with my wife and 4 kids for almost 2 years while building a house. Luckily we had use of a sauna in a separate building next to where we were parked and used that for showering. We were hooked up to utilities as well which is key for any ... more »

Added reply in a thread Benchmade knives stepping in s%^t. 2/22/2019 9:19 AM

Check out their profile on OpenSecrets. While it's not a lot of money, what they do donate overwhelmingly goes to Democratic candidates. Weird times we are in. Look through their instagram page. It's brutal. Benchmade Knife Profile

Added reply in a thread Benchmade knives stepping in s%^t. 2/22/2019 9:03 AM

Because Oregon... What a complete waste of funds as well. Police Department couldn't spend $100 and get a grinder and some discs? Why not auction the guns off if they are legal firearms? Everything is stupid and Benchmade has made a terrible business ... more »

Added reply in a thread YZ 426 opinions 2/6/2019 11:05 AM

Mine must be a unicorn since it starts hot or cold with no issue. I agree it's heavy and ergo's are not what a new bike is, but power is solid and mine has been reliable as anything. I trail ride mostly and it does just fine for what I need.

Added reply in a thread Our local high school is introducing a new PE class.... 3/14/2018 9:57 AM

Not around Portland OR where I live. You are lucky to find a place to park or get a pass at any outdoor area around here.

Added reply in a thread Mx track building 3/9/2018 11:50 AM

I see you're in Amboy. Super nice day to be out today. I'm building a house over by the Grist Mill. Can't wait to be done so I can build some trails/tracks. What machine are you running? Looks like Case? I've got a Mitsubishi BD2G, a 5ton mini and a ... more »

Added reply in a thread How does Kyle have #11 3/6/2018 12:34 PM

Chiz is Chiz.

Added reply in a thread Whoa Bro Trans....neutral (moto related) 12/4/2017 4:13 PM

It sounds like a great role model. Too bad it's not part of the sport anymore. It brings so much to the table. *"It" being the labeless gender neutral being that is "Pink".

Added a comment about photo 450 moto two start 7/12/2016 12:51 PM
450 moto two start

Look at Pourcel's lean angle. That is gnarly.

0 0 0

This photo has 1 comment.