jt.hagerty's Forum Activity

Reply to Spoke With My Wallet - 125 Style 4/12/2021 4:54 AM

For those of you looking for a ride report here ya go..... I rode a local, old school time keeping enduro yesterday. I had around half an hour of ride time on the bike before the race started, the only mods I did to it was change bars and put hand guards

... more »
Reply to Spoke With My Wallet - 125 Style 4/12/2021 4:44 AM

I adjusted the PV on my 125. It's design looks identical to the KTM/Husky system. When I first rode the bike it was smooth, I like the bike to have a pretty good hit in the mid-range. I adjusted it about half a turn and it's almost perfect now.

Reply to Spoke With My Wallet - 125 Style 4/9/2021 10:35 AM

My plan is to install the race harness, Scalvini pipe (maybe silencer), and hopefully a VHM head.

Reply to Spoke With My Wallet - 125 Style 4/9/2021 6:04 AM

First race is Sunday. I have to try to find time to break it in in the next couple days.

Reply to 1994 GASGAS EC 125 3/28/2021 5:12 PM

Made a small amount of progress on the bike today. cleaned the subframe, airbox and triple clamps. I decided to have the framed powder coated to clean up most of the rust and then clear coated. I can't find someone to replate the frame and since I can't

... more »
Reply to Purple is so the 90's 3/26/2021 5:03 AM

Here is a CR I built a little while ago. It has a lot of purple.

Reply to 1994 GASGAS EC 125 3/23/2021 5:59 AM

So a small update on the bike. I've started gathering parts and cleaning some of the aluminum pieces. This thing says Gas Gas everywhere. I have most of the parts to put the chassis together and Ralf at TM has been a great help finding engine parts.

... more »
Reply to 1994 Husaberg 501 3/23/2021 5:51 AM

I finally figured out how to start this thing. It definitely isn't a screamer, the shorter you shift it the faster it goes. I found a small crack in the rear wheel, once I find spokes, I think I'm going to put gold rims on it. I also still need to find

... more »
Reply to 1994 Husaberg 501 3/4/2021 10:26 AM

A little update on the big Husaberg. I installed the correct muffler, changed the blue fender to yellow, tuned the carb and fixed a few other bugs. After spending a couple hours figuring out how to start it, it actually starts fairly easily. I purchased

... more »
Reply to 1994 Husaberg 501 2/17/2021 10:11 AM

Where did you find the smaller tank? The bikes look 100 times better with a smaller tank.

Reply to 1994 GASGAS EC 125 2/1/2021 4:23 PM

I was in the garage looking over some of the bike parts and noticed something cool. The GasGas logo on the tank is actually made in the tank, not a decal. Also, I looked the silencer over. The picture below shows the damage. Hopefully I can coat it with

... more »
Reply to 1994 GASGAS EC 125 2/1/2021 5:00 AM

So yesterday I disassembled the bike. It came apart pretty easy for the most part. The only thing I've had trouble with is the rear axel, its currently soaking in PB Blaster. I found a couple things during the tear down. This bike has had a rough life.

... more »
Reply to 1994 GASGAS EC 125 2/1/2021 4:54 AM

I'm about 99% sure it is an Acerbis carbon fiber silencer. I'm going to do what I can to save it, but it is cracked and the bracket has fallen apart. My plan is coat it with fiberglass resin to try to hold it together and then use a Bud Racing carbon ... more »

Reply to 1994 GASGAS EC 125 1/31/2021 3:43 PM

Not quite sure yet. The linkage looks just like my 93 KX and so does a lot of the other chassis parts. The motor uses a lot of CR parts, like the piston. What I think will be hard to find is the plastics. The rear number plates and part of the rear fender ... more »

Reply to Purple Rims for 90’s Honda 1/27/2021 7:46 AM

I'm super happy with how this thing ended up looking. The right amount of purple.

... more »
Reply to 1997 CR 125 1/27/2021 7:44 AM

Well the bike is pretty much finished. I have two more small pieces that I'm waiting to be delivered, HRC clutch and ignition covers and twinwall bars. I really like the look of the crossbar pad rather than the regular fat bar look.

... more »
Reply to 1997 CR 125 1/10/2021 2:32 PM

I may sell it. Shoot me an email. jhagerty@geigerbrothers.com

Reply to Cost of trucks.. 1/6/2021 10:33 AM

I had a 2 Chevy Colorado's until I bought my wife her 4Runner. After driving it for a little while I knew it was time to trade the Colorado in for a Tacoma. So far it has been the best truck I've had. I have a 2020 GMC Sierra 1500 for a company truck, ... more »

Reply to 1997 CR 125 1/5/2021 1:24 PM

I actually have a full PC system on the bike. I just need to clean it up some. Thanks for the offer.

Reply to 1997 CR 125 1/5/2021 7:20 AM

It's been awhile since I've given an update on this bike. Not that much has changed, new clutch, black rad hoses, purple rims, Applied top triple clamp, original Answer/Easton Pro Taper bars with bar pad. I wish the bar pad wasn't blue, when I bought

... more »