joeyburdette1985's Forum Activity

New thread 2001 YZ250F quick throttle bog 9/26/2017 4:31 PM

Ive read a million post about jetting, mods, everything... and im confident I'll find the problem soon but few questions. First, stock rebuilt 2001 yz250f, fcr carb still, but off a 2002 as mine was trashed to a seized jet. I did the mod with the wire ... more »

This forum thread has 2 replies.

New thread Where to find YZ250F cylinder head 9/7/2017 11:05 AM

I got my 01 YZ250F project bike taken apart and found I dont need a crank but it dropped a valve and the head is in bad shape. Ill need a new piston and head assembly. I have found a few hits on Ebay but they look used and abused and look to need a servicing

... more »

This forum thread has 2 replies.

New thread 2001 YZ250F crank 9/3/2017 8:34 PM

Just picked up a beautiful looking 01 yz250f. It's got, for what I assume, a toast crank. It's locked up mostly. I say mostly because I can put it in gear and rock it back and forth and it moves a little before the wheel locks up and skids. I bought

... more »

This forum thread has 3 replies.

New thread Oh look, another jetting question 8/31/2017 8:36 AM

Hey all, been working on my project RMX 250 for a while and I'm finally getting somewhere. Its a 92 RM250 bottom with the rmx250 top end, Pro circuit platinum head pipe, pro circuit 304 silencer, Vforce3 Reed valve, UNI air filter with the air box lid ... more »

This forum thread has 8 replies.

New thread Rmx 250 main jet question 8/19/2017 11:26 AM

Finishing a rmx250 build with rm250 bottom end. Been chasing around a problem with it flattening out and not hitting power band. Idles good and peppy down low, but anything past half throttle it just wouldn't rev up. Here's the mod list... 1989 rmx250 ... more »

This forum thread has 0 replies.

New thread Rmx vs rm cylinder compatibility 7/23/2017 5:37 PM

Alright guys, another rmx250 question from me. I have found that my bottom end on my 89 rmx250 is beyond worth repairing. I made a bid on eBay for a bottom end to an 89 to 91 rm250 bottom end. My top end is fine. The cylinder and head and piston are ... more »

This forum thread has 21 replies.

New thread RMX250 Cylinder stud question 7/5/2017 10:56 AM

Hey all, rebuilding my RMX250 I just got, and found I need a few studs. 1 that goes into the case from the cylinder, and 1 or more possibly for the cylinder head to the cylinder itself. Is there a place that sells these? Haven't had much luck with old ... more »

This forum thread has 7 replies.

New thread 1994 RM250 FLYWHEEL/Interchange HELP 6/20/2017 8:26 AM

hey all... new to the page... just picked up a 1994 RM 250 and the flywheel is SHOT. Also looks like the stator is in rough shape but thats not a big concern right now. My question is, do any of you guys know if a flywheel rotor would fit from any other

... more »

This forum thread has 6 replies.