Added reply in a thread Garage clean out, rm/rmz 1/19/2020 11:40 AM

$60 2001 rm125 front hub, fits many years

... more »
Added reply in a thread Garage clean out, rm/rmz 1/19/2020 10:30 AM

... more »
Started new thread Garage clean out, rm/rmz 1/19/2020 10:16 AM

-2005 rm125 linkage arm $95 -Msr clutch perch assembly with extra lever $40 -2003 rm125 radiator louvers $15 -fmf shorty silencer $70 pulled of an 05 rm125 but fits other years, repack has about 30mins of run time on it - pro taper oversized bar mounts

... more »

This forum thread has 4 replies

Added reply in a thread ken2h is a scammer! 1/16/2020 3:44 PM

Yea he got me for 180

Started new thread Steering stem spanner nut? 1/12/2020 8:41 AM

Does anyone know where you can get after market aluminum spanner nuts? The oem ones that I know fit are all on back order. I have searched the internet and only find steel or they have a different profile. Is there another name for them maybe?

This forum thread has 3 replies

Added reply in a thread Wanted late model suzuki rm 125 cylinder 1/12/2020 8:24 AM

The 04 cylinder will work. Bruce was saying the 04 powervalves will only work with the 04 cylinder which is correct.

Added reply in a thread Wanted late model suzuki rm 125 cylinder 1/11/2020 5:33 PM

I have a 04 with powervalves but it’s sleeved an bored to a 134. The head is cut for race gas only. Let me know if your interested

Started new thread Looking for a k5 or k6 rm125 crankcase 1/7/2020 8:59 AM

I’m looking for a 2005 or 2006 rm125 crankcase with no repairs done to it. I will also consider a 04 if someone has one. Thanks in advance

This forum thread has 2 replies

Started new thread Rm125 motor swap? 12/18/2019 5:33 PM

Does anyone know if a 06 motor will bolt up to a 04 frame?

This forum thread has 3 replies

Added reply in a thread For those who have done Front end swaps 12/15/2019 9:37 AM

I did one on a 04 rm125. I used the clamps off a 05 they bolted up with no mods. You can also use clamps off a 04 and up rm250. You get rubber mounts and a better offset with these clamps. Some forks may require you to machine the top clamp if they are ... more »

Added reply in a thread The rm 125 dream 12/9/2019 6:41 PM

So I know a few people have said the 05 jug won’t work but I think it will. I heard if you use a rod from an 04 and up the 05 jug will work. You would need the rod, cylinder, head, pv and piston from a 05 . I’m not 100% on this but I read a post on here ... more »

Started new thread Exhaust o rings? 12/9/2019 9:10 AM

Is this the only o ring I need? The fmf kit came with two and the tusk kit came with one that’s wider. Oem diagram shows two but I can’t figure out where another one could go. The pc pipe I had before only had one but maybe I missed something. This is

... more »

This forum thread has 3 replies