08/01/16
You guys are too much on here , there is no bull shit going on buddy! I told him the length of the second blink is the indication of hours on the bike and every second is considered 4 hours and it stays on for about 2 seconds . So get off your high horse ... more »
I did a wear test on a new cover I installed . Then got on the bike and went from a standing position to sitting position till the new cover had the same amount of wear and came up with 10hr .
Super clean under 10 hrs total on the bike I put a high comp piston to give it a little more bottom end had maybe 1-2 hour of run time , has jgr complete Hinson clutch , jgr clutch cable bracket, ahm suspension, kyb shock , linkage , rental bars , odi
This forum thread has 10 replies
I got a new one has 2hrs on it $200 plus shipping , I also have some flow foot pegs in new condition $30
I will be bringing a trailer back to Cali from Nashville Tennessee if anyone is in need of anything be transported along the way hit me up .. 951-675-9989
This forum thread has 1 reply
Bought it brand new and is a little tight wanting to trade for a moto10 xl helmet must be brand new or sell it for what I paid $800 comes with the bag and extra visor . Has only been tried on has not left the house I was hoping to exchange it for a XL
This forum thread has 1 reply
Brand new never used 19” wheel of a 2019 rockstar edition fc450 comes as pictured . Asking $450 951-675-9989
This forum thread has 3 replies
So basically I posted I was looking for a crf450 head and I had a guy private message me saying to email a guy he bought parts from, he
This forum thread has 4 replies
Looking for a 08 head and a 02 crf450r cam but any 02-08 will work 951-675-9989
This forum thread has 1 reply
20hrs on forks 5 hrs since service In great condition asking $700 shipped please text 951-675-9989
This forum thread has 2 replies
Came off a 2019 fc450 with 20hrs and the forks had approximately 5hr after being valved and serviced asking $700 I won’t respond to comments call or text
This forum thread has 1 reply
You have to get the Hinson basket I can get it for you and do $500 for the complete kit
Yes clover hub , pressure plate , springs and the steel and fiber plates you will need to order a basket from Hinson
Ims oversized tank with dry break ready will come with screw cap low hour use I used it on my 2018.5 factory edition sxf450 but it should fit the newer 250/350 also but check with ims asking $140 please text 951-675-9989
This forum thread has 1 reply
Clutch has about 4 hours of use plates are still on like new condition, cover is brand new just needs a new basket runs about $250 from Hinson I can arrange to pick up at buyers expense asking $350 text me 951-675-9989
This forum thread has 6 replies
Rekluse core manual torq drive clutch put about 20hrs with it on my crf450l was a great clutch needs new fibers and steels I have everything else asking $300 text me for more info 951-675-9989
This forum thread has 2 replies
Bump 2,000 forks will fit 450f and yz250 if you run large axle
Low hour forks part #fgya 1896 Shock part # ya 1893 everything is in great condition asking $2500 for both hit me up for more info 951-675-9989
This forum thread has 2 replies
Go with the technical touch kyb kit I have had cone valves and like the kyb setup a lot more
2002 yz250 bike is fully built from the ground up !! Bike was a barn find when I got it with low hours . Every part has been upgraded motor esr 325 cc , Crank works balanced crank, full Hinson clutch , Wide ratio 4,5th gears , every bearing and seal
This forum thread has 10 replies
