I've been using both the xgps and my gopro. The xgps is nice because you can look at your stuff at the track. Otherwise with the gopro you have to upload your video to your computer then drag and drop it into there analysis tool to sync on your Litpro ... more »

Here's another option. They use those skypro's on a lot of air plane and off road stuff so cases and mounts are out there. https://mobarmor.com/dual-skypro-160-gps-case/

I'm in the 175-185 range - summer more towards 175. B level rider. And went with Factory connection for suspension. It feels good at this point, but I do still have some hold up issues under heavier front end braking. I'm 8 clicks out on compression. ... more »

I'm getting ready to list a bike. Is it unrealistic to ask 7500-8K for the following? Picture below - it's not a current picture at work! It's spotless after every ride. Just curious what's realistic / fair - I'm not out to rip anyone off, but obviously

I’m revalved running stock springs. Currently at 108mm started with 105mm. 2mm fork height. Seems to be better, I do feel like even with the revalve the front / rear is soft.

What's the PGM-FI (Programmed Fuel Injection) Malfunction Indicator Lamp do when you try and start it? Does it blink, etc? In your owners manual there should be input on what it means, etc. Should give you an indication of whats going on. Could also ... more »

Is your clutch lever adjusted correctly with the right amount of free play? Check that and break it in a little and see if it starts to feel better. Different clutches / setups will have a different feel (More grabby, etc).

Yeah I’ve not heard a word on the 22 yet.

Man am I confused now, I thought this was a Crf250r thread?!

It’s a different part number but the spacing is the same.

I emailed these guys mtracing250@earthlink.net And they sent me a map list for what I needed, were very fast with a response too.

Yup previous years fit no problem. 2014+

Wheels I built. Excel takasago rims, excel spokes and tusk hubs. It was a backup wheelset to my previous bike. I wanted to try some Hoosiers as I’ve heard good things about them.

Thank you! I really like how it turned out.

Duuudddeee! Your dedication to this build is incredible! I've enjoyed following every bit of it. This bike is awesome!

Not a huge fan of these MX33's, at least not the front. Still also getting the suspension dialed in. I switched to an XPR mapped Vortex - there connection maps are really good so far. The aggressive map makes a ton of power as well.

I've since bought a service manual to have on hand, but I found this months ago when I needed some information right away. It's the whole 2018-2021 crf250r service manual on youtube.... https://www.youtube.com/watch?v=rNZK345JVj4

Ride Engineering actually makes a replacement clamp designed for the smaller diameter stainless lines like you have. https://ride-engineering.com/products.php?d=1&p=b&pn=CR-BLC00-RA&t= Worked great for me, and your not clamping the rubber. ... more »