Added reply in a thread 2010 rmz 250 Bike Build 9/30/2019 6:26 PM

I would get rm 250 it'll fit write in plus all cr yz ktm rm kx basically the same speed it's all about the rider...

Added reply in a thread kawasaki kx65 and kx85 compression readings 9/30/2019 4:52 PM

Well whatever your doing keep doing it because 60 hrs is a lot for a 2stroke normal piston times are around 15 hours...

Added reply in a thread KTM or Husky? 9/30/2019 4:48 PM

Wd40 will clean white to brand new it Evan takes most scratches out....

Added reply in a thread Overheating smell an weird noise 9/30/2019 4:43 PM

Hi I'd do a full strip down and air line clean of all piping.. While striped down put in all new gaskets.. coolent.. Gear oil.. Fuel oil mix shud look like vimto....

Added reply in a thread Overheating smell an weird noise 9/30/2019 4:36 PM

Sometimes problem Is not the bike it's the rider..........

Added reply in a thread New clutch not working right 9/30/2019 4:25 PM

Pls don't try cut corners with these things the bikes deserve looking after.... There not hard to look after...

Added reply in a thread YZ 250 2002 9/30/2019 4:10 PM

I uesd to love my mates yz until I got a cr.. Its Honda what do u expect....

Sadd sight to see kxf 250 dying....
(Member Blog)

9/30/2019 3:43 PM

0
Added reply in a thread Steady idle -> Cutting out midrange -> Flies to high rpm! 9/30/2019 2:55 PM

I had the same problem on a rm 125 a few years back it turned out to be a tiny fracture in the head loss of compression couldn't see with eye just a test on the head hope it helps.....

Added reply in a thread Kxf 250 2012 9/30/2019 2:48 PM

Thank you ime not sure how this site works I just want to help people on here.....

Added reply in a thread Kxf 250 2012 9/30/2019 2:46 PM

Thank u.....

Added reply in a thread Kxf 250 2012 9/30/2019 2:34 PM

Started new thread Kxf 250 2012 9/30/2019 2:23 PM

So ime new to writing posts I read a lot of them and thort ide share a couple with youse... I have just striped a kxf 250 kick was stuck so was thinking piston was stuck or crank but it was a lot worse than I thought. What has happened is the rod has ... more ยป

This forum thread has 5 replies