Added reply in a thread SHIFT MX Pant/Jersey Combos 7/11/2018 10:20 AM

pm sent, email too

Added reply in a thread looking for 5.7 shock spring for 13 kx450f 5/19/2018 5:39 AM

I think some of the WP springs are compatible with the KYB, Check on Factory Connections site. I have a 5.7 WP spring from a 15 FC450.

Added reply in a thread WHAT CRANKSHAFT WOULD YOU PICK 2/26/2018 10:53 AM

Rebuild the stock crank, it will cost about the same and you will have better components than if you went with anything low priced. The stock crank can be pressed apart and new rod and bearing installed. Then re-straightened to likely better than factory ... more »

Added reply in a thread 1986 kx125 project, won't rev out 2/11/2018 1:33 PM

Think you found the problem...

Added reply in a thread 1986 kx125 project, won't rev out 2/8/2018 10:22 AM

How is the compression? 125's need a good top end to run correctly.

Added reply in a thread Enzo tuned 4CS vs stock AER48 forks? 1/22/2018 10:38 AM

I have a 15 FC450 with a MX Tech re-valve with Huck valves, I have no issues with the forks. I did the the KTM demo days when they came to my area last fall, I would say the re-valved 4CS worked just as good as the 18 AER's. If its always going to bother ... more »

Added reply in a thread Fly F2 Carbon MIPS or Suomy MX Jump 12/29/2017 7:32 AM

A Fly F2 saved by bacon last year, I would have no issues buying another one, it was very well made. However I replaced it with a 6D because I believe in there technology.

Added reply in a thread 1998 CR125 (One of the Most hated 125's) The Re Rebuild/ First start/Video Added 12/29/2017 5:42 AM

So sad, the bike with a newer fender and number plate really looked good, still very modern.

Added reply in a thread 1998 CR125 (One of the Most hated 125's) The Re Rebuild/ First start/Video Added 12/28/2017 5:03 PM

Awesome looking ride!! I had a 98 CR250 back in 98 it was my first brand new bike ever, so a 98 has a warm spot in my hart. I got a bunch of hole shots on that thing. I sent a bunch of money on my 01 to make it as fast as my 98.

Added reply in a thread Does this look normal? 05 RM 250 12/28/2017 4:46 PM

The clean areas on the piston are called wash, safe wash is 1/4 -1/2 inch. How did the plug look? A impact screw driver (not a powered on but one you hit with a hammer) will help loosen the screws. impact driver