I know in fiber glass lay ups, there is a magical time for trimming. The epoxy/polyester resin isn't wet, but not quite cured either. Like I said, it's all timing.

Chin bars make excellent handles.

If it's a DT250. The chain is a 520. Here's what I found.

Yep, just see if the chain you have fits both sprockets correctly. Pitch (length between lowest points, and width (fitment between chain plates). I

While I like the ideas, I don't think it's the block that is the problem. It's the cover. Make it out of paper. You could have a vinyl one with the track side paper. A replacement with a little double sided tape, and viola!

Uh, Hamblin won, and Earnhardt Jr. finished 2nd...

...and some people think I have too many guns...

Every flywheel mod I've had has been welded. It's the best way. Even if it was riveted, they drilled holes in the original part. Bite the bullet and buy a replacement flywheel. It will be more balanced even if you are able to remove the weight.

Yeah these are for hobby, but I bet 3 in the chest would make it hard to breathe.

There it is

You evil man.... Just picked this up. Oh,...

Village Creek in Ft. Worth is still running.

Picked up a little water today. Think 14 pallets is enough?

My wife is despondent over the lack of auto racing. She's binging shows about people killing their spouses. I've been trying to catch extra shifts.

As per usual, this thread has gone completely off the rails.

Shitting the doors would be a deal killer.

No kidding. If you would have told me 20 years ago that this is what I would be doing, I would have died laughing.

Maintain the equipment that puts water in little plastic bottles at extremely high rates of speed. it's still not fast enough. 2 weeks ago we were curtailing production a few hours here and a few there because our warehouse was full, and we had no place ... more »

Well, if you want to speak English and shit, it is good info.