Added reply in a thread 2003 HONDA CR250R CASE SAVE REPAIR 10/8/2019 10:06 AM

will try that thanks!

Started new thread 2003 HONDA CR250R CASE SAVE REPAIR 10/8/2019 9:49 AM

I HAD A CHAIN BREAK ON MY CR250. IT BROKE THE UPPER MOUNTING TAB OFF FOR THE CASE SAVER. IS THERE A WAY TO REPAIR THE UPPER MOUNTING HOLE SO I CAN INSTALL ANOTHER CASE SAVER? RIGHT NOW IF I MOUNT ONE UP THERE IS A 1" GAP BETWEEN THE CASE SAVER AND THE ... more »

This forum thread has 3 replies

Added reply in a thread 2003 cr250r rc valve problem 6/16/2019 8:20 AM

Thanks for all the replies. I bought the new motor fro. Bristol but I found a broken wire to the motor so I'll keep the motor as a spare because it sounds like on day I will need it

Added reply in a thread 2003 cr250r rc valve problem 6/7/2019 1:26 PM

i hope after all this it gets rid of the bog/ hesitation in the midrange

Added reply in a thread 2003 cr250r rc valve problem 6/7/2019 11:16 AM

actually i just called bristol racing in syracuse ny and he says he has the servo motors brand new! so i just bought one from him. he said their race team used to race the cr250r for years. i asked about the cdi and he said they never go bad, he never ... more »

Added reply in a thread 2003 cr250r rc valve problem 6/7/2019 10:32 AM

thanks for all your insight, i see threads of people who have changed the motor inside the servo so i way try that. ill follow up how i make out

Added reply in a thread 2003 cr250r rc valve problem 6/7/2019 9:38 AM

would this cause a skip or hesitation at mid throttle, ive read alot about broken wires going to cdi and some cases of a bad cdi which is also not available any more. so i have to look in to it some more. he loves this bike and we got some money in to ... more »

Started new thread 2003 cr250r rc valve problem 6/7/2019 7:55 AM

i have a 2003 cr250r that my son uses for mx. it has pc pipe and silencer, vforce reeds, pwk carb. the bike has always ran flawless. last sunday he was racing and it was muddy. it ran beautiful most of the day and in the last heat it developed a hesitation ... more »

This forum thread has 15 replies

Added reply in a thread 2000 cr250 part out 10/13/2018 1:08 AM

I'm new to the fourms, is there a waiting period before you can receive dm. I don't see any where to check then

Added reply in a thread 2000 cr250 part out 10/11/2018 3:20 AM

is the rear wheel any good? hub ok? looking for wheel, rotor, and sprocket