Thanks man. I actually have the VH800 closed loop cabinet. It sure does a great job. It has definitely taken a lot of man hours out of my builds and customer builds.

The customer had them zinc coated again with the nipples. I also use a corrosion inhibitor spray that works well will a clear coat as well for the budget.

I just cleaned a set of Z spokes with my vapor honing cabinet and turned out great but before I owned my cabinet I would use a scotch bright drill attachment and MPPL maxima.

I’m pumped. Thanks man I appreciate that

Yes it’s a closed loop system. And I am building 2 bikes for Ernesto next. His 450 is in the works right now.

After a few drinks and eBay I found some pink grip tape. Haha

Wow! Thanks man. I enjoy it too much to stop. Haha.

You’re absolutely right. Some killer stuff will be available soon. I’m beyond pumped to see what lies ahead for Stiffie Brand

Thank you very much. I appreciate that

Nice! Was it the glitter seat? Thanks man

Yes I use my vaporblast cabinet. It does an amazing job

A little peak at the mega 90s kit from Stiffiebrand

Once you get it hot enough it will pull right out.

Thanks man. I heat up stripped tank nurserts with a cutting wheel on my dremel . That way they are easily removed. Then I removed the bolt and replace using a two stage epoxy

Thanks man!

Fitted up my Pro Circuit Pipe and silencer

I found some old frame guards and put some spit shine on them

Thanks man! This one should be pretty badass I’m hoping.

Thank you very much. I spend way too much time out there. Haha