MP818's Forum Activity

Reply to XACT PRO (Cone Valve) service parts 5/11/2022 1:17 PM

Yes you can use just a rubber strap wrench. Sometimes have to lightly heat the seal casing where it threads to the fork tube. Service parts are the same as standard WP AER forks.

Reply to Langston van STOLEN 5/7/2022 7:26 PM

Anyone down voting this is brain dead.

Reply to Help with a revalve 4/28/2022 5:53 AM

It shouldn’t, but you could always put that 18mm down below the .3x10 to keep the stack height. It would just be a spacing shim which is very common. Float is more so designated for the midvalve compression stack which is below the piston that the rebound ... more »

Reply to Help with a revalve 4/27/2022 4:57 PM

Nope, just start your collection. That area would affect more of your round shaped, rough sections. It sounds like you’re looking for just a little more hold up all together.

Reply to Help with a revalve 4/27/2022 12:29 PM

Remove one of the 18mm OD face shims on the piston. Those 2 .15x18 are acting as bleed shims to allow more oil in before affecting the stack. You could also get rid of the .3x10 clamp shim at the bottom which will make the entire stack stiffer since ... more »

Reply to Wtb yz250 expansion chamber 3/18/2022 5:48 AM

I have a pretty much brand new complete stock system I’ll let go. It has maybe 6 hours of ride time on it. 214-934-9995

Reply to Garage Workbench Ideas/Plans 4/13/2021 7:04 AM

Made my frame out of 1inch square tubing and 2in angle. The top is 3/4inch sanded plywood that I sealed and then topped with 16g 304 Stainless. I think I was a total of $220 range for materials. ... more »
Reply to Houston 4 and 5? 1/27/2021 7:17 AM

Fox, you’re probably right on that lol

Reply to Let's see your white Yamahas 1/23/2021 2:32 PM

Reply to Supercross track build 11/6/2020 8:52 AM

If I remember correctly for rythym lanes the measurements are as follows. All faces and landings built at a 2:1 ratio. For instance the small singles are typically 3ft tall. So the bottom of the jump is 6ft out from the top of the lip. 3ft tall small ... more »

Reply to $100 Bike Raffle 7/22/2020 1:53 PM

You must have not read what all it is including. Coated fork tubes, fully built suspension for the winner, day at the track to dial in the bike, new plastic color of winners choice, sprockets, chain, etc,. Plus 2 other drawings included for a free suspension ... more »

Reply to $100 Bike Raffle 7/22/2020 11:32 AM

Understood. It was worth a shot to try and speed up the process of selling this bike. It’s done quite frequently on Facebook with success. I’ve seen some real s**t boxes get raffled off in two days LOL

Reply to Whats the most amount of bikes you've owned at one time? 5/29/2020 4:47 PM

Owning is 3, with a ‘16 YZ125, ‘18 YZF450 and a ‘19 YZ250. Got rid of the 125 a few months back. In my racing days I owned a ‘10 RMZ 450, ‘08 RM 250 and ‘12 RMZ 250. At the same time had 5 stock/mod ‘13 RMZ 250 and 3 ‘13 RMZ 450 loaned to me. Could’ve ... more »

Reply to Question for Avgas Users (100ll) 5/4/2020 11:49 AM

An airplane’s most critical time of flight is leaving the ground and then upon landing. I’ve ran it in every 2 stroke I’ve owned for the last 15 years mixed with Motul 800 with absolutely zero issues. A good jetting spec is important on anything with ... more »

Reply to 50/50 avgas mixed with 95? 9/12/2019 5:46 AM

https://m.vitalmx.com/forums/Race-Shop,42/Pump-or-AV-has,1291970

Reply to 50/50 avgas mixed with 95? 9/12/2019 3:38 AM

I’ve been running straight 100LL av gas in my last, I don’t know, 8 or 9 2-strokes. Never had one issue at all. Currently running it in my YZ125 and 250 mixed with Motul 800 at 36:1

Reply to Who would win in a fight out of last 30 years of pros 8/13/2019 5:11 AM

Ronnie Faist (sp?) Billy Bolt Tyler Bowers

Reply to Star Racing Yamaha Suspension 5/23/2019 9:28 PM

That’s just KYB/Technical Touch Kit suspension with the air fork option. You can buy that online for the most part.

Reply to Help me find this Langston moment on Pulp MX 5/13/2019 10:45 AM

Which episode is “Schlong Shot” and “Winning races and smashing pussy”? 317?

Reply to 2018 kx250f suspension set up, harsh braking bumps 5/12/2019 8:41 PM

Sorry man, but whoever told you that is wrong. Opening the rebound does make it faster, yes, but NOT stiffer. The mid speed/ midvalve compression is a part of that circuit and will make the softer.