Added reply in a thread XACT PRO (Cone Valve) service parts 5/11/2022 1:17 PM

Yes you can use just a rubber strap wrench. Sometimes have to lightly heat the seal casing where it threads to the fork tube. Service parts are the same as standard WP AER forks.

Added reply in a thread Langston van STOLEN 5/7/2022 7:26 PM

Anyone down voting this is brain dead.

Added reply in a thread Help with a revalve 4/28/2022 5:53 AM

It shouldn’t, but you could always put that 18mm down below the .3x10 to keep the stack height. It would just be a spacing shim which is very common. Float is more so designated for the midvalve compression stack which is below the piston that the rebound ... more »

Added reply in a thread Help with a revalve 4/27/2022 4:57 PM

Nope, just start your collection. That area would affect more of your round shaped, rough sections. It sounds like you’re looking for just a little more hold up all together.

Added reply in a thread Help with a revalve 4/27/2022 12:29 PM

Remove one of the 18mm OD face shims on the piston. Those 2 .15x18 are acting as bleed shims to allow more oil in before affecting the stack. You could also get rid of the .3x10 clamp shim at the bottom which will make the entire stack stiffer since ... more »

Added reply in a thread Wtb yz250 expansion chamber 3/18/2022 5:48 AM

I have a pretty much brand new complete stock system I’ll let go. It has maybe 6 hours of ride time on it. 214-934-9995

Started new thread WTB Rear shock 8/26/2021 1:35 PM

2001+ KX85 shock or shock shaft needed please.

This forum thread has 2 replies

Added reply in a thread Garage Workbench Ideas/Plans 4/13/2021 7:04 AM

Made my frame out of 1inch square tubing and 2in angle. The top is 3/4inch sanded plywood that I sealed and then topped with 16g 304 Stainless. I think I was a total of $220 range for materials. ... more »
Added reply in a thread Houston 4 and 5? 1/27/2021 7:17 AM

Fox, you’re probably right on that lol

Started new thread Houston 4 and 5? 1/27/2021 6:15 AM

Local radio stations are now giving tickets away for the Orlando dates, February 13th and 20th. Sorry if there was a topic about this already!

This forum thread has 3 replies

Added reply in a thread Let's see your white Yamahas 1/23/2021 2:32 PM

Added reply in a thread Supercross track build 11/6/2020 8:52 AM

If I remember correctly for rythym lanes the measurements are as follows. All faces and landings built at a 2:1 ratio. For instance the small singles are typically 3ft tall. So the bottom of the jump is 6ft out from the top of the lip. 3ft tall small ... more »

Started new thread Barndominiums 7/29/2020 4:05 AM

How many of y’all out there live or own a Barndominium on some property? What was the rough cost for the buildout? What are some pros and cons you’ve experienced over the time?

This forum thread has 52 replies

Added reply in a thread $100 Bike Raffle 7/22/2020 1:53 PM

You must have not read what all it is including. Coated fork tubes, fully built suspension for the winner, day at the track to dial in the bike, new plastic color of winners choice, sprockets, chain, etc,. Plus 2 other drawings included for a free suspension ... more »

Added reply in a thread $100 Bike Raffle 7/22/2020 11:32 AM

Understood. It was worth a shot to try and speed up the process of selling this bike. It’s done quite frequently on Facebook with success. I’ve seen some real s**t boxes get raffled off in two days LOL

Started new thread $100 Bike Raffle 7/22/2020 5:29 AM

I may get flamed for this, hopefully not. ***RAFFLE with 2

PRIZES*** Going to do a raffle for my 2018 YZF450 and free suspension service. $100 a ticket with a minimum of 80 available spots. Cash, check, Venmo @rideMP or PayPal @ ... more »

This forum thread has 14 replies

Added reply in a thread Whats the most amount of bikes you've owned at one time? 5/29/2020 4:47 PM

Owning is 3, with a ‘16 YZ125, ‘18 YZF450 and a ‘19 YZ250. Got rid of the 125 a few months back. In my racing days I owned a ‘10 RMZ 450, ‘08 RM 250 and ‘12 RMZ 250. At the same time had 5 stock/mod ‘13 RMZ 250 and 3 ‘13 RMZ 450 loaned to me. Could’ve ... more »

Added reply in a thread Question for Avgas Users (100ll) 5/4/2020 11:49 AM

An airplane’s most critical time of flight is leaving the ground and then upon landing. I’ve ran it in every 2 stroke I’ve owned for the last 15 years mixed with Motul 800 with absolutely zero issues. A good jetting spec is important on anything with ... more »

Liked a comment on the item Social Scoop 2/26/2020 7:39 PM

Awww pwecious wittle snow fwake .. getting mad at a flag on a sand buggy?? Buhahaha goddam loser

Added reply in a thread 50/50 avgas mixed with 95? 9/12/2019 5:46 AM,42/Pump-or-AV-has,1291970