Kachmar829's Comments

Added a comment to Kachmar829's bike check 4/11/2020 8:08 AM
2019 KX 450

Couldn't use a hyperlink for photo in comments so I added a picture to the bike check at the very end, My buddy is a machinist and designed/made it from the backside of a perch clamp I had. Its made of black plastic and uses longer allen head bolts.You can also search G2 Ergonomics they make a 6mm spacer but its $26. You can find it on ebay. Also strongly consider the ARC CL-412 Lever. The powerlever I bought was $130 retail but it allows you to change the pull engagement (prob not needed). The 412 is $69 retail and is set up with the ARC recommended pull for half the cost. The stock set up hitting your fingers and where it engages can cause the clutch to slip without you knowing and can aid in premature wear out (so I read). Thanks!

0 0 0

This setup has 7 comments.

Added a comment to Kachmar829's bike check 4/10/2020 8:35 PM
2019 KX 450

I used your products because of the simplicity of the design and the countless hours of testing you guys put into them. All for a fraction of what some of your competitors charge. #nobrainer thank you guys.

This setup has 7 comments.

Added a comment to Kachmar829's bike check 4/10/2020 8:32 PM
2019 KX 450

Yep, did that. Fiber added. Rekluse has a 12 plate kit to use with the oem internals. Going that way very soon.

0 0 0

This setup has 7 comments.