Added reply in a thread Anyone have advice on bending ti tubing? 5/22/2011 4:48 PM

A little too much time on the hands?

Added reply in a thread Help decarbonising 4 stroke header pipe 5/22/2011 4:46 PM

Send it on in to FusionOneUSA.com and we'll blast it out for $15.

Added reply in a thread Anyone have a RM300 big-bore kit (2-st)? 5/21/2011 12:49 PM

What size is your 04 KX? A 285cc? Was it ported too? Wjhich company did the work? Thanks.. How do you like the handling of the 04-07 KX250?

Added reply in a thread Look for good Mx track near Charlotte, NC 5/20/2011 7:41 PM

Millsaps Training Facility ?

Added reply in a thread Anyone have a RM300 big-bore kit (2-st)? 5/20/2011 6:40 PM

Anyone out there done this ? I heard it's better to port and stick with the std bore and a have a good top end overrev /pull because the big bore goes flat on top. I would rather hear from a customer/end user than to listen to the opinions of a shop ... more »

Added reply in a thread Anyone have a RM300 big-bore kit (2-st)? 5/19/2011 5:34 PM

That KTM deal would be the way to go, but $7500+ is over my budget .... I'm thinking $2500 for the bike + $800 for the kit....

Started new thread Anyone have a RM300 big-bore kit (2-st)? 5/19/2011 5:18 PM

I'm looking to switch back to a 250 2-stroke from a CRF450, for MX use, but want a bit more power with quick-handling, so I'm thinking the '07-08 RM250 with a 295cc kit from E.Gorr or Maxpower. Does anyone have any experience with this kit ? Does the ... more »

This forum thread has 7 replies

Added reply in a thread Rock Hard 5/7/2011 9:31 PM

Micheals is a douche nozzle. All he does is talk about himself.

Added reply in a thread Noleen/Ohlins 360 Kit 5/7/2011 11:47 AM

So can these guys > FusionOneUSA.com

Added reply in a thread Dust masks for riding 4/8/2011 4:29 PM

No-Toil panty hose

Added reply in a thread Old national tracks,,,, 4/5/2011 6:17 PM

Southwick, back when it was a real track with the big steep hills like the frogpond, skyshot, camel backs ... now it's too flat and easy ...

Added reply in a thread Any Ti-welders around? Input needed... 4/2/2011 8:12 PM

$25

Added reply in a thread Any Ti-welders around? Input needed... 4/2/2011 7:56 PM

Send it to FusionOneUSA.com ... we perform Ti-weld repairs like that everday, guaranteed not to crack again.

Added reply in a thread expansion chamber crack 3/11/2011 5:41 PM

Unless you have the ability to clean both inside and outside of the crack and have argon gas backup on the opposite side of the TIG weld, you are making a temporary repair. Braze joints do not have 1/3 the strength of a properly performed TIG weld. Likewise, ... more »

Added reply in a thread Dents in expansion chamber 3/11/2011 5:34 PM

Don't freeze it. This process ussually results in split seams because when the water freezes, the expansion is not controlled. Send it to www.fusiononeusa.com or piperepair.com and get it done right.