Need advice on suspension tuning. Looking at factory connection and pro circuit. Have you guys had any luck with either with the 2019 or 2020 450? Wanting to send mine off this week and have it back before December is over.

Thank you!!

What is the toque spec on the two nuts on the exhaust flange? I looked through my book and it’s not listed and I don’t have the service manual. Installed a PC Ti-6 yesterday and it’s the only torque value I’m missing. Any help would be appreciated

I bought the like new ones from the bazaar, they arrive Friday

Just bought a pair of XTRIG rocs pro clamps. Anyone have this set? Has you tried the 21 offset and what did you think?

I’ve seen people do it without problems. I buy rubber o-rings and pull it over the outer fork tube onto the leg, works very well and gentle on coatings. Only have to take one fork off. Could probably just slide the fork up and do it without fully removing ... more »

Finishing up the graphics on mine (not completely done). Completely greased up, going to change the fork oil in 5-10 hours. Waiting on on pc ti-6 to come in.

Was lucky enough to get a dealership to sell me one in the crate. Grease was minimal. Put belrays waterproof grease on all bearings and it usually lasts a full season. Guess I’m going to need to check the fork oil!!!

What part of Tennessee are you in? I also have a 2019 KX and I'm in Memphis TN

He rode Saturday. He did not ride Sunday on the day many had issues

Multiple bikes were affected. Over 10 from the posts I’ve seen. The track owner made a joke in response to everyone who brought it to his attention.

bump

Have you seen ankle savers footpegs?