Added reply in a thread What happened to this piston ? 6/6/2021 4:41 PM

Broken Impeller

Added reply in a thread 2017 KTM 250 SX-F Electrical Demons 6/6/2021 4:38 PM

Have seen a cracked subframe do this also

Added reply in a thread Greasing your bike - what grease do you use? 6/5/2021 8:55 PM

Bel Rey on linkage, swing arm, headset - very tacky Motor rex 2000 for general and axles, bolts - slick

Added reply in a thread Last effort before splitting the cases rm250. Burning gear oil. 6/5/2021 8:51 PM

Cases not sealing Time to rebuild

Added reply in a thread Hey guys what’s works best for removing graphic glue? 6/5/2021 8:46 PM

Rag and Gas

Added reply in a thread Solved: Fork Rebuild: Rebound Adjuster not hitting spec 6/5/2021 8:43 PM

Put back together and count clicks If different than normal pull apart and check rod

Added reply in a thread Last effort before splitting the cases rm250. Burning gear oil. 6/5/2021 8:37 PM

Pull pipe and see if oil runs out

Added reply in a thread 2017 KTM 250 SX-F Electrical Demons 6/5/2021 8:33 PM

Disconnect the starter switch at connector make jumper and jump to see if turns over If doesn't start jump at starter relay next jump starter Have had broken wires under oem zip ties

Added reply in a thread Last effort before splitting the cases rm250. Burning gear oil. 6/5/2021 8:18 PM

Smell is coming from burning your clutch Whats condition of clutch?

Added reply in a thread YZ125 Wont Crank Up 6/4/2021 2:23 PM

pull flywheel an check timing marks of stator plate take spark plug boot off and clip some off for fresh end

Added reply in a thread Yahama pw50 wont run 6/4/2021 2:15 PM

Make sure in the carb that the nozzle insert is in the carb the needle runs thru this part the main jet holds it in customer brought bike w one missing bogged everytime you cracked throttle open

Added reply in a thread Help - Oil Leak Issue 6/1/2021 11:51 AM

Are you letting the oil drain down completely after stopping motor to get accurate site glass reading?

Added reply in a thread 2018 Ktm 250 starter wire broken at 4 pin connector 6/1/2021 11:47 AM

Eliminate Oem connector put new barrel connectors Wires break cause of the way the connector is mounted sideways wires flex up an down and break

Added reply in a thread Outer fork tubes- are they anodized or ceracoated ? 5/31/2021 11:34 PM

Anodized Get with Paulie at RG3 NJ

Added reply in a thread Kickstarter Lever replace? 5/31/2021 11:31 PM

Get with dealer Those have been an issue and can be warrantied

Added reply in a thread Ktm clutch engagement 5/22/2021 6:21 PM

Re bleed system

Added reply in a thread 2020 FC450 Knocks into gear when rolling the wheel 5/17/2021 9:40 PM

This is a common problem with the Austrian bikes the neutral position on the star gear is the problem Have fixed a few

Added reply in a thread Crank? 5/15/2021 2:34 AM

Rings, valve stem seal, head gasket

Added reply in a thread Crf450 mechanical water pump seal 5/13/2021 5:13 PM

you tube: 2009+mechanical water pump seal replacement

Added reply in a thread Crf450 mechanical water pump seal 5/13/2021 5:03 PM

there is a oem part number for the tool from honda service manual this is aftermarket kit piece