Added reply in a thread Yz 125 3/25/2021 1:23 PM

That brass piece looks like a pin out of a key lock or else a tip for some kind of tool?

Added reply in a thread 2008 Crf250r Wont idle 3/25/2021 12:24 PM

https://jdjetting.com/fcr-carburetor-slide-and-vacuum-release-plate-square-end-must-be-oriented-down/ FCR Carburetor slide and Vacuum Release Plate (square end MUST be oriented down)

Added reply in a thread A 125 for a practice bike. Should have done this yrs ago. 3/25/2021 10:44 AM

02-07 CR125 is one of the best handling bikes ever. I compare my 2021 husky 125 to that bike. Similar blend of cornering and stability. I had a YZ125 prior to my Husky. The Husky/KTM engine, once jetted properly, is better in every way than the YZ125. ... more »

Added reply in a thread Flame out issues on 21 350 XC-F? 3/25/2021 8:49 AM

Two things to check first, TPS and idle speed. Those two things are the biggest factor in flame outs.

Added reply in a thread Jd jetting carb yz125 3/24/2021 8:12 PM

For the price of those you can buy the Stock YZ Mikuni. The Mikuni runs very good on the YZ125. If you get a Keihin you will probably be chasing your tail trying to get the jetting dialed and that will be an additional cost for jets, needles, and possibly ... more »

Added reply in a thread A 125 for a practice bike. Should have done this yrs ago. 3/24/2021 8:35 AM

I do 125/350. Mostly practice on the 125 because it's fun and to keep hours off the 350. But I am like you. I can adapt to each and go relatively the same speed, but it takes a few motos to reacclimate. On a 125 you have your right wrist locked back ... more »

Added reply in a thread 30+ ab, 30+ cd, 35+, 40+ab and 40+cd is stupid 3/22/2021 1:05 PM

You should maybe go back and read my original post. All of it. I literally stated it doesn't matter at the end of the day. And I did not complain they should get out of the way. You're making shit up.

Added reply in a thread Slick Products/ProGlow Wash worth the extra $$? 3/22/2021 1:02 PM

Don't wash in direct sunlight and don't let it sit on there until it dries. Keep it wet until you rinse it off.

Added reply in a thread Garmin for training question(s) 3/22/2021 7:47 AM

I use a Garmin Forerunner 235 for Moto and various different Edge for bicycle. You are doing good by using a chest strap for moto. The built in HR monitors on the Garmin watches are notorious for being hit or miss on accurately reading your HR. I'd say ... more »

Added reply in a thread KTM 450 top end gasket question 3/21/2021 9:53 PM

The 4x are your valve seals and the 2 o-rings look like your valve rocker shaft seals.

Added reply in a thread $25,000 Dollar 1984 RM250 on the 'Bay 3/21/2021 2:32 PM

Traction Rivets.

Added reply in a thread 2019 KTM SXF Rear Shock Tool 3/21/2021 2:12 PM

The one you have pictured is the one I use on my 2020 and 2021. So I think you'll be good. Even with the tool, if the threads are really stuck it helps to have one guy twisting the spring while another is turning with the tool.

Added reply in a thread Shoei VFX-Evo/WR fit 3/20/2021 9:07 PM

Sounds like you've got more of a round shaped head. I've had both the US market and Japan domestic market VFX and the Japan version definitely had a more round/Asian shape to it. They do sell optional thinner and thicker interior pads. You could either ... more »

Added reply in a thread 30+ ab, 30+ cd, 35+, 40+ab and 40+cd is stupid 3/20/2021 8:39 PM

Haha, OK. slow guys on 450's can turn the throttle wide open on the start and cause a nice pileup. And many of these local tracks are so skinny and 1 lined that when you come up to lap a pack of six +50C guys clogging up the track no amount of speed

cool
... more »
Added reply in a thread 2019 KTM SXF Rear Shock Tool 3/20/2021 8:20 PM

There is room for a spanner. KTM/Husky make a specific one for it that is curved to make access easier. On some bikes the threads of the plastic ring really grip on the shock body threads and it's impossible to spin it by hand. If you use a hammer and

... more »
Added reply in a thread 30+ ab, 30+ cd, 35+, 40+ab and 40+cd is stupid 3/19/2021 9:23 PM

Ehh.. there's Pros and Cons to everything. Many local races there are only 3 guys per each vet division so they combine all the Vet classes in one moto, many times with only 1 gate drop. As a faster Vet-pro or 40-A guy it is pretty frustrating having ... more »

Added reply in a thread REP suspension service 3/19/2021 8:09 PM

My buddy had his 2019.5 FE done by REP. It was pretty good but I would say it was on the firm side. It had too much hold up (wouldn't settle) and was not quite supple enough on chop. He ended up running less air pressure and less compression than REP ... more »

Added reply in a thread Another one BITES the DUST!!!😥 3/18/2021 11:24 PM

You guys keep forgetting Mesquite MX and the oldest track in the state - Nomads!! Yea I know it's a shell of it's glorious past self, but it's still there.

Added reply in a thread Yamaha 450s in SX 3/17/2021 3:06 PM

On the bright side, the Yamaha team truck stands the best chance of all of them of not blowing away in the tornadoes today.

Added reply in a thread Help "read" this piston and plug 07 CRF450R 3/17/2021 9:59 AM

Yep looks like oil. Time for a re-ring and valve seals, at a minimum. Make sure to check the head gasket closely as well.