Added reply in a thread Back on Japanese 2018 CRF450R 10/9/2017 7:14 AM

When i got my hinson clutch for the 17', the old man at Hinson told me HRC runs an extra 250cc of oil w/ the 8 plate kit. And i should be fine with 200cc. Been working great ever since. The new clutch seems to widen the friction zone at the lever as ... more »

Added reply in a thread Show us your 2017 crf450 9/22/2017 1:12 PM

$90 for both
Added reply in a thread Show us your 2017 crf450 9/21/2017 6:00 PM

I installed the 18' engine mounts on my 17' last weekend, while at the competive edge and i was impressed. I feel like it gives the bike a more forgiving feel whenever the front or rear touches the ground initially. The newer mounts are 1/2 mm thinner ... more »

Added reply in a thread Best Knee Braces 8/18/2017 10:15 PM

When i was in this position, i kept complaining to my family physician about motocross hurting my knees and the bike, aggravating the same inner knee area. Finally she sent me to a Prosthetics specialist, he insisted the over the shelf CTi's should be

... more »
Added reply in a thread Show us your 2017 crf450 6/23/2017 3:36 PM

I left enough slack in the zipties to allow the tank to move around a bit.

Added reply in a thread Show us your 2017 crf450 6/23/2017 10:31 AM

I replaced the 2 rear tank bolts w/ zipties and it seemed to have a slight effect. Seemed to give me a softer feel over smaller braking bumps at Cahuilla. The same article suggested removing the mid-pipe bolts, that I haven't tried.

Added reply in a thread X trig clamps crf450/250 fitment 6/6/2017 8:13 PM

When i bought my clamps from Rick at KYB in November. I asked him the same question and he told me yes. The 2mm difference in the lower tubes was achieved by using thinner upper tubes. So the clamps will work. The steering stabilizer mount is still there, ... more »

Added reply in a thread CRF problems 4/10/2017 6:44 AM

This was my only issue. At 12 hrs the spring on the decomp failed. Causing the bike to not start, the e starter sounded like it was fighting the compression stroke so i had an idea what was wrong.

Old spring/ New spring
Added reply in a thread Show us your 2017 crf450 4/4/2017 8:15 PM

So I pulled the plug and it turned over no problem everytime. Pulled the valve cover and saw my spring on the decomp broke. Did i wind it up to much ? This happened on my 150f to.

Added reply in a thread Show us your 2017 crf450 4/3/2017 10:09 AM

Im at 12hrs on the bike, and 3 hrs with the e-start installed. Having an issue w/ the e start after washing the bike yesterday. I used a pressure washer alot stronger then my own, boom. Electrical issues. Everything checks out but the starter itself, ... more »

Added reply in a thread Post your favorite pictures of you riding! 3/21/2017 7:01 PM

Added reply in a thread Honda CRF 450R 2017 Electric Start Battery 3/21/2017 5:08 PM

i went to ktm and purchased a WPS lithium battery.

Added reply in a thread Honda '17 CR450R throttle grip problem 3/20/2017 5:45 PM

I still have the stock cans, I got what i asked for, Ron at Tokyo mods charged me $100 for the remap. When I install an exhaust, bring it back and he will re flash it again for free, he gets more power out of it. I just wanted him to clean up the bottom ... more »

Added reply in a thread Honda '17 CR450R throttle grip problem 3/19/2017 10:40 PM

Inconsistent/ low fork oil height in the forks. Check the engine mount torque specs No grease in linkage, swingarm bearings, headtube Had tokyo mods reflash the ecu $100 1-time fee Switched oil to Maxima 10w-40 non-syn & coolant to engine ice, seemed

... more »
Added reply in a thread Show us your 2017 crf450 2/14/2017 8:36 PM

Dan from Think! has foam and these "seat springs" he has Roczen using, for the CRF.

... more »
Added reply in a thread Show us your 2017 crf450 2/13/2017 12:36 PM

Sorry guys, Stock on the CRF is 4.8N/mm Fork springs w/ a 54nm shock spring. Alex at Pro Circuit recommended we jump up 2 spring rates, front and rear. So they installed 5.1 N/mmFork springs with a 5.8 nm shock spring. The suspension on this bike was

... more »
Added reply in a thread Show us your 2017 crf450 2/12/2017 9:56 PM

I spent about $400 labor $500 parts Heres a snap of the parts PC swapped & gave back to me.

... more »
Added reply in a thread Show us your 2017 crf450 2/12/2017 7:37 PM

Picked up my suspension from Pro Circuit Friday. PC shock & fork springs are now available for the CRF. They nailed the revavle 1st try, im stoked. Bones gave me much more bottoming resistance, and comfort on the decel bumps. Im 190 lbs, 5.1 kg fork

... more »
Added reply in a thread Who uses knee braces?? 1/21/2017 7:31 AM

Wearing cti braces saved my soft tissue when i had a Tibia Plateau injurt at pala last year. Back at it with no problems, the 6 month recovery process was insane though. Might have UCI take my screws back out soon. Injury was in 12/11/15 Started walking

... more »
Added reply in a thread Show us your 2017 crf450 1/19/2017 9:52 PM