Added reply in a thread How is Ty Masterpool not signed? 11/23/2020 9:28 AM

Worth noting, big brother Jake rode the 1st heat, went from 5th to 3rd. LeBlanc, Vohland, and himself all running 1:03’s, but Jake is on a bike he picked up a week or so ago and hasn’t raced a 250 since Bercy of 2016 (I think). I’m excited for people ... more »

Added reply in a thread McElrath tests MCR - (with gear rant).... 10/24/2020 2:20 PM

Just to play devils advocate to the OP, let’s consider if he did buy and wear a brand from his local shop. Let’s say he buys fox, and perhaps O’Neal is considering him if whatever team he lands on allows it. Who’s to say the interested party might think, ... more »

Added reply in a thread Can anyone reccomend me some cleaning products? 9/16/2020 4:49 PM

Best kept secret in cleaning. I’ve heard of guys who detail cars for a living buying the gallon jugs of this stuff and trying to find who makes it for Suzuki.

Added a comment about feature Movers & Shakers from Loretta's 2 8/24/2020 7:47 PM

Dalton Dyer literally let everyone go off the start of 450 moto 2, because the first moto he had water splash into the airbox on the start. So his 19th at the end of lap one is pretty damned impressive.

0 0 0

This feature has 2 comments.

Added reply in a thread 2023 RMZ450 8/3/2020 7:10 PM

That looks like the black plastic spacer that goes between the throttle housing and front brake master cylinder to make sure the dealer building the bike doesn’t assemble it with the brake lever sticking out an inch past the bars.

Added reply in a thread 2019 RMZ 250 mapping couplers 7/6/2020 9:16 PM

White is -4% leaner, white with black tape is stock, gray is +4% richer. No ignition timing changes. Personally, I think the gray gives a bit more overrev, and the white one is better down low.

Added reply in a thread Answer Racing in Trouble? 7/6/2020 3:57 PM

Hey big guy, sorry to ruin yours and gnarwhip’s day by committing the cardinal sin of trying to get a resolution to an issue that I’d been getting 0 response on, and warning fellow consumers. Here’s a few cliff notes of this story for me thus far: 1:

... more »
Added reply in a thread Suzuki has let go of the R&D department 7/2/2020 8:19 PM

3 hours 56 minutes in.

Started new thread Answer Racing in Trouble? 6/30/2020 7:40 AM

So I bought two sets of Arkon gear recently because it looked pretty sharp and fairly vented. On my second day of wearing one set, the seam on the back of the left thigh ripped apart from right above my knee to the top. Last week I used their contact ... more »

This forum thread has 82 replies

Added reply in a thread 2019 RMZ250 6/11/2020 8:09 AM

So, I received my camshafts back from Webcam. This is who makes the cams for several engine builders, including JGR. I had the privilege of speaking with Melissa there, she answered about 100 stupid questions, and always called me back when she had to ... more »

Added reply in a thread Seven MX gear quality 6/2/2020 5:29 AM

I had the opposite luck with the annex gear. Ordered two sets, they were too big in the waist, and too small in the knees. As a result, every time my knees bent it pulled the pants down, and if I was sitting it split the seams on the back. Lasted all ... more »

Added reply in a thread Showa Spring A-Kit From 2020 KX250 5/20/2020 6:54 PM

I believe he still has them.

Added reply in a thread WTB A-kit forks and shock 19-20 kx450 5/16/2020 4:56 AM

My friend still has this set:,26/Showa-Spring-A-Kit-From-2020-KX450,1375264

Added reply in a thread Showa Spring A-Kit From 2020 KX250 4/30/2020 5:12 PM

Any takers for $3,000?

Added reply in a thread 2019 RMZ250 4/26/2020 9:20 PM

Well, my suspension settings likely aren’t something you’d enjoy as we’re on different ends of the spectrum. I’m 6’5” and 195 lbs, so I run stiffer springs with the Race Tech gold valves. I would try a lighter spring rate front and rear for starters ... more »

Added reply in a thread Showa Spring A-Kit From 2020 KX250 4/23/2020 6:44 PM

Some better pics of the fork legs for a better idea of their condition. Willing to separate, $1250 for shock, $2250 for forks and clamps.

... more »
Liked a comment on the item You Think Your Bike Is Worthy Of Bike Of The Day? 4/23/2020 5:45 PM

So.... the more cheesy aftermarket glitter the better..... as long as the photo is good? A proper restore to original is much more time consuming that a new bike with a bunch of aftermarket fluff on it....

Started new thread Anyone Tested an FMF 4.1 vs. a Powercore 4? 4/22/2020 4:25 PM

As the title suggests, I was wondering if one of the engine builders on here had ever compared the two muffler offerings from FMF, or if anyone had any real world experience with both systems on the same bike. If this should be in Tech Help section, ... more »

This forum thread has 1 reply

Added reply in a thread 2019 RMZ250 4/22/2020 7:10 AM

So far the 450 just has a holeshot device, Mika Metals RC bend bars (15mm taller), and getting rid of the Bridgestones. That bike in stock trim is a great bike for the second half of the day. For instance, doing the Texas Winter Series they gave one ... more »

Added reply in a thread 2015 Rmz450 best oil type? 4/22/2020 5:34 AM

One would think this would be stating the obvious, but since people are recommending other OEM's oil, why not run Ecstar 9000, the full synthetic oil that Suzuki recommends? Or their new MX9000 that JGR developed? For break-in purposes they are filled ... more »