Hi - new member looking for some advice. I am restoring a 79 YZ125 - it did run when I bought like 2 years ago. Fast forward and I am finally restoring it but I have hit a road block. I have no spark issue that I traced to a bad stator. I purchased a ... more »
Brian_Merriman
- Lives in:
- Washington, MI USA
- Member since:
03/04/19
Added reply in a thread 1979 YZ125 Restoration - hit a road block need advice
Well I couldn't wait until the weekend because I had a good feeling that this was the fix I needed. I cut a off nub of a bolt that fit inside the puller, gave a couple turns with the breaker bar and the SOB popped right off! @mx317 thanks so much for ... more »
Added reply in a thread 1979 YZ125 Restoration - hit a road block need advice
I know I have checked out your build a few times before - I didn't remember that part but I will review Thanks!
Added reply in a thread 1979 YZ125 Restoration - hit a road block need advice
Damn man - never considered that - I think that might be what's going on. This weekend I will add a spacer and if that fails I think I have an concept for a two part puller. Thanks Again!
Added reply in a thread 1979 YZ125 Restoration - hit a road block need advice
@motogeeze - Thanks yep - have the correct puller, have soaked it for a week with PB Blaster, heat, beat, etc. The particular puller for this flywheel apparently just pushes against the crank end and it's only 18mm. I might have to try and fabricate
Started new thread 1979 YZ125 Restoration - hit a road block need advice
This forum thread has 12 replies
- @cache_main: fac49ccf582ee753bdc5c6e2d3f7e200/all
