Added reply in a thread 2014 KTM 250 sxf no spark no fuel pump power 11/3/2015 5:13 AM

The pickup coil acts as the crank sensor. Is there a tip over sensor on this bike? That would kill the power to the fuel pump like the issue I have.

Added reply in a thread 2014 KTM 250 sxf no spark no fuel pump power 11/2/2015 7:20 PM

OK. Should I be able to see power at the fuel pump plug when I hit the button?

Added reply in a thread 2014 KTM 250 sxf no spark no fuel pump power 11/2/2015 5:09 PM

Does anyone know what signals the ecu to ground the power relay? It appears it should ground the white/black wire of the relay but I am not sure what signals the ecu to do so.

Added reply in a thread 2014 KTM 250 sxf no spark no fuel pump power 11/2/2015 3:59 PM

Ok I had time in the shop this afternoon so here is an update. Battery voltage is good, even swapped batteries. Checked stator resistance, it is good. Checked voltage from stator with multimeter, it would show ~19v AC. But I know meters are really too ... more »

Added reply in a thread 2014 KTM 250 sxf no spark no fuel pump power 10/27/2015 12:29 PM

I will check the regulator wiring, I just got a manual today so I can start troubleshooting.

Started new thread 2014 KTM 250 sxf no spark no fuel pump power 10/27/2015 7:32 AM

As stated, the bike won't start and has no spark or fuel pump power. Checked the basics, battery voltage, fuses etc. No power going to the coil and it is not lighting the FI light. Anyone ran into this?

This forum thread has 36 replies

Added reply in a thread Looking for KTM 250SX Crank 9/22/2015 7:59 PM

I haven't tried the hot rods crank with a different rod personally, but I have read several posts on thumpertalk where people had good luck doing that. I know from experience the rod is the issue on the hot rod crank. Cooksey will get it true if you ... more »

Added reply in a thread Looking for KTM 250SX Crank 9/22/2015 4:04 PM

Cooksey is very good to deal with. He just did a 85sx crank for me last week. He may have something.

Added reply in a thread Looking for KTM 250SX Crank 9/22/2015 7:01 AM

What if you bought a Hot Rods crank and replaced the rod with a Pro X. Most of the issues seem to be the rod on the Hot Rods cranks.

Added reply in a thread Looking for KTM 250SX Crank 9/22/2015 6:59 AM

3-6 days doesn't mean they have it. That is estimated time on when they will receive it from the KTM warehouse. I once waited almost 5 weeks when it said the same thing. I don't remember if it was Motosport or RMATVMC, but they use the same setup. It ... more »

Added reply in a thread Auto repair advice needed 8/13/2015 9:57 AM

As a former ASE Master Tech(let them expire), airbags aren't as scary as many make them out to be. Disconnect the battery, pull the airbag fuse for extra safety, let the truck sit about 10 minutes, cycle the light switch a couple of times to drain any ... more »

Added reply in a thread 02 CR250 build, price dropped 3/10/2015 5:06 AM

PM'd you

Added reply in a thread Spoke Torque Wrench 2/24/2015 5:13 AM

Thanks dogger, went to order it but they didn't have any of the heads I needed or the kit so I just went with the Excel. I wish it was made in the US like the Fasst.

Added reply in a thread Spoke Torque Wrench 2/23/2015 12:04 PM

Honda service manual call for like 34 in-lbs. The main reason I want the wrench in to keep them consistent.

Added reply in a thread Spoke Torque Wrench 2/23/2015 9:35 AM

Any idea where to get one? I haven't found a place yet that has them in stock.

Started new thread Spoke Torque Wrench 2/23/2015 8:55 AM

Looking to buy a torque wrench and it looks like the Fasst is no longer available. I have found an Excel but you have to buy a lot of the heads separate. I also found an OTC that comes with all head sizes but it had horrible reviews on amazon. I know ... more »

This forum thread has 20 replies

Added reply in a thread Tell me all you can about the 2004 CR250R.... 6/2/2014 10:36 AM

Bringing this back.......I have a 03 250 I traded for. I love the bike just trying to straighten it out. It still has the TMX carb and it came with a JD kit. The bike had the blue needle on 3rd clip when I got it, and sputters rich at part throttle. ... more »