Added reply in a thread Kick a** two strokes! 10/13/2017 8:47 PM

... more »
Added reply in a thread Help setup my AER48 forks 10/8/2017 6:58 PM

You have to check the air pressure constantly. The pressure will change with ambient air temp changes. I've had mine change 6psi from my basement to the track. I've noticed if the pressure raises in the forks it won't settle into the corners very well. ... more »

Added reply in a thread KTM Battery Dead!!!! 10/8/2017 8:14 AM

Mine junked out at 8.4 hrs on my '17 350. I don't think the dealer charged the battery properly from the get go, cause it never really seemed right.

Added reply in a thread 70hp 2017 KTM450sxf 10/8/2017 6:37 AM

Junior Jackson from Fun Mart Cycle in Illinois has been making 73-75hp KTM 450's and YZ 450's for a couple years now. Dudes motors are legit! Very pricey though.

Added reply in a thread 2003 rm 125 engine help 5/23/2017 4:16 PM

Possibly part of the cage from the lower rod bearing?

Added reply in a thread YZ 125 (something went through motor)? 5/7/2017 8:00 PM

This is how I checked the bearing. Scratch awl with a hook at the end. I was able to spin the bearing and inspect all the needles in the bearing. I must have rolled that bearing around 50x thinking I missed something.
Added reply in a thread YZ 125 (something went through motor)? 5/7/2017 7:19 PM

I'm guessing the ground strap on the spark plug got broke off by the piece beating around in the combustion chamber. If you look and the small silver specs on the head it's evidence that the piece was beating into the dome on end as well (basically stabbing). ... more »

Added reply in a thread YZ 125 (something went through motor)? 5/7/2017 5:08 PM

Started new thread YZ 125 (something went through motor)? 5/7/2017 5:01 PM

This was in the exhaust pipe. I've checked the wrist pin bearing and all is good, I've checked the lower rod bearing and all is good, there are NO needles missing. Rod is tight up and down, and does not have excessive side play either . This ... more »

This forum thread has 6 replies